红水杯

anavi-info-uhat: Open source hardware Raspberry Pi add-on board with mini-OLED display, buttons and sensor slots.

Overview

ANAVI Info uHAT is a low-cost, open source Raspberry Pi add-on board with a mini OLED display, 3 buttons, red and green LED indicators, and slots for various sensors. Each kit includes a 0.96" yellow-blue I²C OLED display with a resolution of 128x64 single white OLED pixels. This is a low-power display that emits its own light, so no additional backlight is required. Additional slots allow connectivity Various I²C temperature sensors, humidity, light and air pressure as well as UART pins for easy serial communication ANAVI Info uHAT follows the official Raspberry Pi uHAT mechanical specification and has a valid ID EEPROM.

Design Files

anavi-info-uhat

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-08-04 13:53:21

Installation problem of spcomm control in delphi
After installation (there is a red control in SYSTEM), put the SPCOMM control into the form, compile and pop up the SPCOMM unit file without writing a line of code. It fails to compile, as if a code u
51 interrupt problem, I am going crazy
The INT0 interrupt of 51 has always been normal, but every time a function that generates a rectangular wave is called, the microcontroller does not enter the interrupt program even if there is an int
Question: How to distinguish the size of ATMEL memory (how many K)?
I recently bought a few ATMEL memory chips from a merchant. I want 128K, but I always feel that it is not as big as the 32K I originally wanted. The chip I have now says: ATMEL316 24C256N SI27A. The b
Is the STM32 RTC really related to the crystal oscillator?
As for crystal oscillators, I have checked many manufacturers, and their worst accuracy is ≤50PPM, which means that there is only an error of 1 pulse in 20,000 pulses. For a 32.768kHz crystal oscillat
First upload a paper on FPGA-TFT
The TFT controller has not been completed yet, and the SRAM used on our board is a 70NS chip, which seems to be difficult to meet the requirements. I hope everyone can give some suggestions on this TF
Looking for a wifi module with sdio interface under xscale
I am now planning to make something similar to a mobile phone platform, which needs to support WiFi and GPRS. I am using an xscale processor and the operating system I am planning to use is Linux. At

Datasheet More

Circuits More