rKWfNznPA0

QCC3034 Bluetooth 5.2 Headphone Amplifier

Overview

Copyright
Notice__________________________________________________________________________________________________________________________________________________________This
project is under CC-BY-NC-SA (i.e. Creative Commons-Attribution-Non-Commercial-Share Alike)
This project is for DIY and learning purposes only. It is prohibited to use this project for any commercial activities (selling, disseminating, and copying for the purpose of profit)Including but not limited to the above three pointsAppearance
(not yet perfect, lacking a shell)

Subsequent upload of the shell file has been verifiedRelated
performanceInput
: 5V@1ABattery
voltage range: 3.2V~4.2VBattery
capacity: 800mAhAudio
output: 384Khz@32bitNoteBattery
charge and discharge protection is not integrated in the projectPlease add an additional charging board

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-22 16:47:09

Please tell me the next lm3s uart question
UARTFIFODISable(UART0_BASE); At the beginning I disabled the UART0 FIFO.Then use the uart_echo routine to debug the program.I found that the serial port tool should have shown Enter test: string, but
【DIY Creative LED】Main Component Description
[i=s]This post was last edited by dcexpert on 2020-9-16 22:54[/i]The main devices used in DIY:LED Light WS2812 Light Ring ESP-WROOM-02 module TTP223 CH330N TP4054 74LVC1G32Note: The prices shown are f
Design of automatic loading scheme for TMS320C6701
[i=s] This post was last edited by Baboerben on 2019-1-8 17:04 [/i] [size=5] Loading scheme design [/size] [size=5] When BOOTMODE[4:0] is set to 01010B, the program is loaded from the external 8-bit p
GD32F chip problems and solutions
In the initialization of GD32F, the frequency division coefficient is initialized with a library function. In the xxxx_init function of the cycle, there is a code for the software update event. If you
40 "Millions" of Raspberry Pi Cars - ROS Learning (C Language Programming to Control the Turtle)
[i=s]This post was last edited by lb8820265 on 2022-11-1 14:52[/i]In the previous section, we introduced how to run the "turtle_teleop_key" node and then control the turtle with the keyboard . If you
【GD32-colibri-F350RX】IAR & Keil blank project
My Keil was installed on a non-C drive. I failed to compile the official examples directly, so I downloaded the official firmware library and created blank projects for IAR and Keil. The IAR version i

Datasheet More

Circuits More