PLfy3h

CH343 Mico For ESP32

Overview

#Introduction The ESP downloader produced using CH343 is mainly used for data downloading of Espressif related modules, serial port debugging, etc. For QFN package, it is recommended to use solder paste + hot air gun for soldering. #Whether it has been verified that the board has been printed# Notes: TX, RX and other hardware do not use protection mechanisms. When used in systems above 5V, please pay attention to safety! ! ! !

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-30 06:52:29

Selection of regulating valve
In the selection of control valves, we must first consider whether it can achieve the process objectives, meet the control requirements and be used stably for a long time. As we all know, the adjustme
80C51F020 MCU cross switch problem 2
How to control the general IO port cross switch? For example, I want to set p2.3 p2.4 as the chip select signal terminal, how do I set these two ports? p2mdout=?
Asking a wiring specification question?
According to the standard: 220V AC uses red wire, 380V AC uses black wire, and 24V DC uses blue wire. Usually we only have these three situations, but we also encounter 110V AC, 12V DC, and 5V DC. Wha
Has anyone written a 12864 data reading program?
Hello, seniors. Has anyone written a 12864 data reading program? I wrote the program according to its reading timing, but the data read out is always wrong uchar Read_Dat() //12864 reads a byte functi
They are all six non-gates. This power supply can be used even if it is connected reversely, but it cannot be replaced.
RT, I'd like to share a board made by my dad's company. At the beginning of the development, they used a part that they had some stock on hand. Motorola's six-NOT gate chip was finished, but it was di
About attachment size
How do I upload an attachment larger than 15M?

Datasheet More

Circuits More