5C9VeE

C2979600_WiFi module solution verification board based on ESP-12

Overview

ESP-12F is a Wi-Fi module designed based on ESP8266, supporting the standard IEEE802.11 b/g/n protocol and the complete TCP/IP protocol stack. Users can use this module to add networking capabilities to existing devices or build independent network controllers. This solution verification board is based on the ESP-12F minimum system circuit design, uses USB port for power supply, integrates USB to serial port, and has all pins drawn out, making testing convenient and faster.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-18 22:38:24

AD9361 RF Agile Transceiver
Software Defined Radio (SDR) combines RF to baseband transceiver PHY and digital processors to provide a reusable and future-proof radio platform. SDR has many advantages, including software configura
S5PV210 Timer
There are 4 types of timing devices in S5PV210, with different functions and features. 1. PWM timer(1) This is the most commonly used timer. The timer we usually refer to is this one. The timer in a s
【PCB Design】Fully Automated Schematic Verification
[i=s]This post was last edited by ohahaha on 2018-3-19 15:19[/i] [align=left]Craig Armenti[/align][align=left]PCB Marketing Engineer at Mentor Circuit Board System Division. He has over 25 years of ex
Detailed explanation and selection of pull-up resistors and pull-down resistors
[size=4]1. Definition[/size] [size=4] [/size] [size=4]1. Pull-up means embedding an uncertain signal at a high level through a resistor! "The resistor also acts as a current limiter"! The same applies
FLYBUCK circuit, transformer primary voltage problem
[i=s] This post was last edited by powered on 2015-12-25 16:11 [/i] In the FLYBUCK circuit, I want the negative voltage of the primary side of the transformer to be 5v, but after a period of time, the
How to solve CAN response errors and how to set CAN identifiers
CAN response error, how to solve it? Is the CAN identifier setting incorrect? How should I configure the identifier? Or other, send file parameters. [[i] This post was last edited by benbending on 201

Datasheet More

Circuits More