太白金星

4-in-1 ESC

Overview

The traversing machine has a four-in-one ESC, and the BLS firmware responds quickly. Supports up to DSHOT600 protocol. The hole spacing is the standard hole spacing of 30.5*30.5.
It took more than half a year to make this ESC intermittently. Five or six versions were changed in the middle, and almost a dozen tubes were blown up. The following is

the PCB file of the production process:
schematic diagram:
welding:
front and back of the board:
Installation:

It is currently installed on my ducted small four-axis Shuangfei

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-09 13:40:27

When programming a microcontroller, doesn't a programmer need one? Why can I program directly using the serial port to ISP interface on the development board I bought?
When programming a microcontroller, doesn't a programmer need one? Why can I program directly using the serial port to ISP interface on the development board I bought?
STM8TIM1-PWM does not output
void main ( void ){_asm("rim");PC_DDR |= 0x0E; /* Output. */PC_CR1 |= 0x0E; /* PushPull. */PC_CR2 = 0x0E; /* Output speed up to 10MHz. */TIM1_ARRH = 0x10; //Output pulse period 16MHz/65535TIM1_ARRL =
Download program error
0x00, byte in file: 0xFF Sun Jun 05 15:03:09 2011: Warning:Sun Jun 05 15:03:09 2011: Warning: Too many verify errors, only the first 200 are displayed Sun Jun 05 15:03:09 2011: Fatal error: There were
Make your own wifi switch esp8266 lua development
[i=s] This post was last edited by Clone Master on 2018-11-8 20:13 [/i] Let's take a look at the esp8266-12f control schematic diagramLet's upload the tools used first: Android version of the mobile n
A simple question about ad conversion
I want to use AD conversion to collect data with a sampling frequency of 1280 Hz, collect 128 points and process them, and then collect the next data after processing; Due to the high frequency requir
Want to develop an impact test system
Want to develop an impact test system Impact test monitoring system 89C51 single-chip computer system to display and control the analog and digital signals of the two channels collected by PCI in real

Datasheet More

Circuits More