super_star

D-STPR-GEVK: Dual Stepper Motor Driver Daughter Evaluation Board

D-STPR-GEVK: Dual Stepper Motor Driver Shield Evaluation Board

Overview

The Dual Stepper Motor Driver Shield Evaluation Board evaluates the AMIS30543, a micro-stepping stepper motor driver for bipolar stepper motors. It has an on chip voltage regulator, reset output and watchdog reset able to supply peripheral devices. The chip is connected through IO pins and a SPI interface with an external microcontroller that is regulated through the PCA9655E's 16 bits

of General Purpose parallel Input and Output (GPIO) expansion.
Power Supply needed:Digi-Key Mouser

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-25 21:49:27

Is it very slow to simulate DSP on CCS?
As the title says, I am using CCSv3.3, C6713 simulator. It takes several minutes to run a program with a large amount of calculations. It only takes one or two seconds to run it directly under Windows
EEWORLD University Hall----TI Automotive Intelligent Processor
TI Automotive Intelligent Processor : https://training.eeworld.com.cn/course/80Part 1: Introduction to TI's automotive application processors? ? Automotive electronics is an area where TI focuses on i
[ACM32F070 supporting capacitive touch development board target -- Arduino preparation for dual-machine UART communication linkage]
[i=s]This post was last edited by JohnMatthrew on 2022-11-5 23:30[/i]It was a very pleasant experience, and it was easy to get started with this development board. Although I have used STM32, I usuall
(Awarded) Download and win phone bills: ADI Programmable Logic Controller (PLCs) Solution
[font=新宋体][size=5] PLC systems consist of power supplies, CPUs, and multiple analog and digital I/O modules that can control, execute, and monitor complex machine variables; PLCs are designed for mult
Seeking high-speed data transmission solution between ARM and FPGA
ARM and FPGA need to transmit 160000*7 data. The current SPI communication method takes about 4 seconds. Is there any solution to increase the data transmission rate?
Where is the TIM interrupt vector of STM8S?
The interrupt mapping in the document only has TIM1234, why is there no 56? How can I write the interrupt function?

Datasheet More

Circuits More