0sgdMVCt5p

STM32F411-BOARD

Overview

2018051406009 Liu Yutai
contains the minimum system schematic diagram and peripheral circuit schematic diagram

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-22 23:52:53

About DSP's CPLD
When doing an LED experiment, the data says that the LED is output through the I/O of the CPLD, but there is no corresponding circuit or data about the CPLD. Baidu said that the DSP controls the IO po
Seeking scientific knowledge points
Does anyone know how to implement wireless image transmission based on 2530?
GPIO block diagram of C6000 series DSP
First, take a look at the GPIO block diagram:By looking at the GPIO block diagram, we can get a lot of information: The DIR register controls whether the GPIO pin is input or output, where the corresp
How to minimize crosstalk in cable design
[i=s] This post was last edited by dontium on 2015-1-23 11:45 [/i] Start with a intensive reading of Texas Online's "Home? Social Media? Analog Technology Controversy? How to Minimize Crosstalk in Cab
What to do if the IRQ of NRF24L01 module is always high?
Please help me, thanks a lot. According to the manual, there are three situations when IRQ becomes low level, why is mine always high? void TX_Mode(uchar * BUF) { CE = 0; SPI_Write_Buf(WRITE_REG + TX_
About downloading issues
I downloaded the interface made in EVC to the target version, and the following error always appears--------------------Configuration: 1485 - Win32 (WCE ARMV4) Release-------------------- Compiling...

Datasheet More

Circuits More