XXkPeFtrQg

Assignment 5 555 circuit and its simulation

Overview

none

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-08-05 01:01:18

Problems encountered when writing C language for microcontrollers for the first time
The first time I taught myself C language for microcontrollers, I bought a development board from Taobao and used Keil to write programs. I had learned C++ before, so the program was OK, but I encount
tlc5615 program
[i=s] This post was last edited by paulhyde on 2014-9-15 09:07 [/i] Debugged tlc5615 program, 10-bit serial DA~~ [[i] This post was last edited by open82977352 on 2011-7-26 09:27 [/i]]
About JLink automatic firmware update problem
I got a JLink today, the model parameters are as shown below.However, there was a problem. After connecting to JLink, it always prompted that the version was too low and needed to be upgraded. As soon
On the feasibility of the traditional brake transformation of stepper motor
[i=s]This post was last edited by Fengmangbulou on 2019-6-20 17:46[/i]Ordinary stepper motors will not self-lock when the power is off, but will self-lock when the power is on. To achieve self-locking
Digital tube display
Is it complicated to make such a thing? http://www.51c51.com/bbs/uploadfile/2007-8/200783010452232507.jpg The target is set with a button or remote control, the actual and defective are increased by b
AD627 amplification signal problem
rt:I use AD627 to amplify AC signals, single power supply (+2.3V), a 0.1uF capacitor for the power supply, AC signal is supplied by a signal generator (5=20mV), I connect the AC signal directly to the

Datasheet More

Circuits More