yXBtunaYxS

[MCU] Minimal system design based on STC32

Overview

Minimal system design based on STC32, source: https://oshwhub.com/wei-lai-dian-zi-gong-zuo-shi/zui-xiao-xi-tong-stc32g12k128-hid-xia-zai
Development board can It implements the relatively basic function of controlling the LED light by pressing the button. The test program uses the STC official test program and the function is normal.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-07-03 12:53:49

I2C slave address problem
I am using the F4152 microcontroller.The slave address of my I2C device is 0xa0.I wrote 0xa0 into the UCB0I2CSA register.After sending the slave address, the I2C device could not receive it.Later, aft
Several methods to solve EMI consistency,,,
[i=s]This post was last edited by qwqwqw2088 on 2018-7-26 08:24[/i] [size=4] At low frequencies, the impedance of circuit nodes in a system can vary greatly; this requires some circuit or experimental
What should the AD part circuit of the MCU AD detection look like?
The current method is to directly connect the voltage to be sampled to the analog input of the microcontroller, so the measured voltage value fluctuates greatly. Let's see if anyone has any good solut
How to configure the remote frame of the CAN module
[size=5]How should the CAN module remote frame be configured? Some people on the Internet say that it can be configured to receive. How should the specific configuration be performed? [/size]
ADuM4151, SPI isolation design
Has anyone done ADuM4151, SPI isolation related design, please provide reference
DS18B20 reading and writing problems.
/** * 18B20 write 1 byte function * Write a byte to 1-WIRE bus */ void write_byte(unsigned char val) { unsigned char i; for (i=0; i>=1; not shifted left? Isn't it moving from the low bit to the high b

Datasheet More

Circuits More