AIf72y2Q

Infineon motherboard for intelligent vehicle off-road group

Overview

The PCB design of the Infineon motherboard for the 18th National Undergraduate Intelligent Vehicle - Extreme Off-Road Group
has a rather bulky appearance due to the mounting holes.

The schematic diagram
, power supply circuit, and interface section can be used as a simple reference, intended to spark further discussion.

A power supply voltage
of 12V-16V is recommended; theoretically, higher voltages are possible, but please test according to the voltage tolerance of your components.
The power supply voltage diagram is shown below.

The interface
section includes redundant designs to accommodate modules with different interfaces.
Please insert the Taobao-Zhufei Technology-Infineon TC series core board.
Please insert the Zhufei Technology-Gyroscope sensor.
The button board project (5 button modules) is attached; please open it with JLCEDA Professional.

It is recommended
to use this project in conjunction with the brushless driver board project.

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2026-03-26 14:12:06

Several issues with op amp circuits
As shown in Figure 1, the input signal VIN is given by the DSP chip. In Figure 1, R3 and C1 as well as R2 and C3 form a two-order low-pass filter. What is the principle of this filtering? It is easy t
How to write a USB Camera driver
My teacher asked me to write a USB Camera driver, but I don't know where to start. I have no idea what to do! I am using VS2005, and I don't know what project to create. The driver is compiled into a
Continue to the programming problem of IIC bus for beginners
The device has not been returned these days. I can't verify it in practice. I wrote a function to write one bit of data for IIC communication as follows (#define uchar unsigned char) void write(uchar
Upload a good book
Designed for embedded image processing on FPGA Chinese name: Design of embedded image processing based on FPGA
Wince audio driver structure
[p=26, null, left][color=#333333][font=Arial]Wince has 3 audio modes: MDD/PDD, WaveDev2 and UAM. [/font][/color][/p][p=26, null, left][color=#333333][font=Arial]1. MDD/PDD: A model commonly used by Wi
USB and SD/MMC porting notes (transferred)
[font=宋体][size=12pt]1. USB transplantation After transplanting the kernel and file system, carry out USB transplantation. S3C2440 integrates USB controller to support USB1.1 version, and supports USB

Datasheet More

Circuits More