Ovens and stoves

Large household appliances

Mobile POS

Single coil wireless charging solution

The 65W single-coil wireless power solution includes controller, software and hardware, all documented and fully tested, enabling rapid transition from prototype to production. Scalable form factors and parameters support a wide range of use cases and applications such as electric scooters, fixed wireless access outdoor units, vacuum cleaners, power tools, drones and more.

15 W LDO Wireless Charging Receiver Reference Design

15 W Buck Wireless Charging Receiver Reference Design

High voltage wireless charging receiver

Schematic PCB

BLE based voice solution

PX4 Robotic Drone Vehicle/Flight Management Unit (VMU/FMU) - RDDRONE-FMUK66

Schematic PCB

Two-Phase Power Meter Reference Design

As global energy consumption continues to grow, especially in the residential market, utility providers require increasingly accurate and cost-effective energy metering solutions. The Kinetis® M Series two-phase energy meter reference design meets these accuracy and cost requirements by providing a high-performance analog front end combined with an embedded programmable gain amplifier to improve the accuracy of energy measurements.

Schematic PCB

Totem Pole Bridgeless PFC Converter

This reference design demonstrates totem pole bridgeless power factor correction (PFC) using the MC56F83783, MC56F81xxx, or MC56F82748 digital signal controller (DSC).

Schematic PCB

KV46 Digital LLC Converter Reference Design

This provides a fully digital design of LLC resonant converter based on HVP-LLC. The HVP-LLC development board is part of the NXP® High Voltage Platform.

Combined with the HVP-KV46F150 control card, it provides a ready-made software development platform for a 250-watt power supply with an input voltage of 390V DC and an output of 12V/21A.

Schematic PCB

KV series quad-core motor control

Schematic PCB

LLC resonant converter with synchronous rectifier

This reference design demonstrates the implementation of an LLC resonant converter using the MC56F83783, MC56F81xxx, or MC56F82748 digital signal controller (DSC).

Schematic PCB

Three-Phase Power Meter Reference Design

The three-phase power meter reference design is used to measure and record active and reactive energy in directly connected three-phase networks. It is pre-certified to the European EN50470-1, EN50470-3, Class B and Class C, and IEC 62053-21 and IEC 62052-11 international standards for active energy class 2 and class 1 electronic meters.

Schematic PCB

KV Series Full-Bridge DC-DC Switched Mode Power Supply (SMPS)

The full-bridge DC-DC switch mode power supply reference design is based on V-Series MCUs and is intended to provide examples of power conversion applications. A full-bridge DC-DC converter is a transformer-isolated step-down converter. The full-bridge topology consists of a full-bridge inverter module, transformer, synchronous rectifier module and filter.

Schematic PCB

S08 sensorless BLDC control

Sensorless BLDC control at ultra-high supply voltages (up to 18 V) is often required in many applications such as drone ESCs and DC fans. This reference design is based on NXP's highly integrated 8-bit S08 microcontroller MC9S08SU8/16. With its compact design, the BLDC control board delivers outstanding performance at a very low cost.

Schematic PCB

Four-motor control development platform - Introduction

Schematic PCB

Rapid-IOT drone adapter board

Schematic PCB

Smart battery management for mobile robots

Schematic PCB