This is a routine from TI's official website. The frequency of the msp430f2618 DCO is set by an external resistor (ROSC). It is compiled with IAR and downloaded and simulated through the JTAG port of ...
Today, I was doing a recording experiment with STM32 and encountered a problem where the speaker kept beeping. I would like to ask for help. The situation is this: the board is SEM32F4 Explorer V2.2, ...
I was in an Internet cafe and found that the system does not allow dynamic loading of drivers on the computers in the Internet cafe. Any program that can dynamically load drivers, such as CPU-Z or Vir...
Thanks to eeworld, I am very happy to get the "trial voucher" of "Operational Amplifier Parameter Analysis and LTspice Application Simulation". In fact, I had my own purpose in applying for this book....
Traditional broadcasting systems generally need to be operated manually at a fixed time, and can only realize one-way broadcasting with few functions. Traditional bell ringing equipment has a singl...[Details]
Sailing is gaining more and more attention. How to use modern technology to assist training and improve competition results is particularly important. Considering the real-time data collection in t...[Details]
1. Circuit composition
The whole circuit consists of two parts:
1. Power saving control circuit
As shown in the figure below. Including delay circuit and drive circuit.
(1) Delay ci...[Details]
1. Introduction
With the growth of parking demand, the scale of parking lots is becoming larger and larger. A lot of research has been done on intelligent parking lots in China, but most of th...[Details]
Converged processors meet scalability requirements
In current embedded system design, solutions based on MCU, DSP, FPGA and ASIC account for more than 90% of the market share. These solutions ...[Details]
introduction
MEMS is a high-tech that has flourished on the basis of integrated circuit production technology and dedicated micro-electromechanical processing methods. Pressure sensors develop...[Details]
1. Introduction
AS-Interface bus technology is an intelligent network that uses a single cable to connect sensors and actuators to controllers, transmit data, and provide power. It can be used...[Details]
Button cells (also called button cells) are those batteries with equal or larger diameter and height. The current size range of alkaline button cells is specified as follows: diameter 4.8mm-11.4mm,...[Details]
Since the implementation of the self-weight toll collection system, the highway administration has not only high requirements for the vehicle axle recognition rate, but also requires a long service li...[Details]
During the operation of electronic equipment,
memory
failure or failure will not only lead to economic losses, but also may lead to catastrophic consequences. Therefore, memory testing has ...[Details]
In the process of designing electronic products, we usually control the cost of the designed products, always try to simplify the circuit, reduce the components, and simplify the installation process....[Details]
1 Introduction
At present, with the growing calls for environmental protection and energy conservation, new types of transportation that are pollution-free and have diversified energy configur...[Details]
Abstract Based on the overview of the hardware design of digital synthesis sweeper, this paper describes a USB2.0 interface design based on ISP1362, including the hardware structure design of USB i...[Details]
Power over Ethernet
(POE) Overview
POE (Power Over Ethernet) refers to the technology that can provide DC power to some IP-based terminals (such as IP phones, wireless LAN access points ...[Details]
The progress and development of computer technology and modern communication technology have made Zigbee technology mature. This system has established a mesh network based on the Zigbee2007/PRO proto...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
