EEWORLDEEWORLDEEWORLD

Part Number

Search

800S-N048

Description
800W Single Output With Parallel Function
File Size312KB,3 Pages
ManufacturerMEAN WELL
Websitehttp://www.meanwell.com
Download Datasheet Compare View All

800S-N048 Overview

800W Single Output With Parallel Function

800W Single Output With Parallel Function
Features :
SCN-800
series
AC input range selected by switch
Protections: Short circuit / Overload / Over voltage / Over temp.
High reliability/ Low ripple noise
Built-in remote sense function
Built-in remote ON-OFF control
Built-in parallel operation function
Can adjust from 20~100% output voltage by external control 1-5V
Forced air cooling by built-in DC fan
Case coating with paint
2 years warranty
SPECIFICATION
ORDER NO.
SAFETY MODEL NO.
DC VOLTAGE
RATED CURRENT
CURRENT RANGE
RATED POWER
OUTPUT
VOLTAGE ADJ. RANGE
LINE REGULATION
LOAD REGULATION
SCN-800-12
800S-N012
12V
66A
0 ~ 66A
792W
SCN-800-15
800S-N015
15V
54A
0 ~ 54A
810W
150mVp-p
SCN-800-24
800S-N024
24V
33A
0 ~ 33A
792W
240mVp-p
20~100% adjustment by 1~5VDC external control
1.0%
0.5%
0.5%
SCN-800-48
800S-N048
48V
16.6A
0 ~ 16.6A
796W
480mVp-p
1.0%
0.5%
0.5%
RIPPLE & NOISE (max.)
Note.2
150mVp-p
5.0% typical adjustment by potentiometer
1.0%
VOLTAGE TOLERANCE
Note.3
1.0%
0.5%
0.5%
0.5%
0.5%
SETUP, RISE, HOLD UP TIME
800ms, 50ms, 16ms at full load
90 ~ 130VAC / 180 ~ 260VAC selected by switch, 260 ~ 370VDC
VOLTAGE RANGE
FREQUENCY RANGE
INPUT
EFFICIENCY (Typ.)
AC CURRENT
INRUSH CURRENT (max.)
LEAKAGE CURRENT (max.)
OVERLOAD
PROTECTION OVER VOLTAGE
OVER TEMPERATURE
WORKING TEMP.
WORKING TEMP., HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
SAFETY STANDARDS
WITHSTAND VOLTAGE
47 ~ 63Hz
80%
17A / 115VAC 9A / 230VAC
60A / 230VAC
3.5mA / 240VAC
110 ~ 135% rated output power
Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover
110 ~ 135% follow to output set up point
Protection type : Shut down o/p voltage, re-power on to recover
>100
/ measure by heat sink, near transformer
Protection type : Shut down o/p voltage, re-power on to recover
-10 ~ +65 (Refer to output load derating curve)
20% ~ 90% RH non-condensing
-20 ~ +85
, 10 ~ 95% RH
0.04% / (0 ~ 50 )
10 ~ 200Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
Design refer to UL1950, CSA22.2, IEC60950
I/P-O/P, I/P-FG:1500VAC
I/P-O/P, I/P-FG, >100M Ohms / 500VDC / 25
81%
85%
87%
SAFETY &
ISOLATION RESISTANCE
EMC
EMI CONDUCTION & RADIATION
Design refer to FCC part 15 class A
(Note. 4)
HARMONIC CURRENT
----
EMS IMMUNITY
----
MTBF
OTHERS
DIMENSION
PACKING
SPECIAL FUNCTION
120khrs min. MIL-HDBK-217F (25
/ 70% RH
)
291*132*68mm (L*W*H)
2.3kg; 8pcs/ 24kg /CARTON
DC voltage adj., Remote sensing, remote control, parallel operation (refer to terminal instruction manual)
NOTE
1.All parameters are specified at 230VAC input, rated load, 25 70% RH ambient.
2.Tolerence: includes set up tolerance, line regulation, load regulation.
3.Ripple & noise are measured at 20MHz by using a 12" twisted pair terminated with a 0.1uf & 47uf capacitor.
4.The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
File Name:SCN-800-SPEC 2007-11-01

800S-N048 Related Products

800S-N048 SCN-800 SCN-800-15 SCN-800-12 SCN-800-24 800S-N015 800S-N024 800S-N012 SCN-800-48
Description 800W Single Output With Parallel Function 800W Single Output With Parallel Function 800W Single Output With Parallel Function 800W Single Output With Parallel Function 800W Single Output With Parallel Function 800W Single Output With Parallel Function 800W Single Output With Parallel Function 800W Single Output With Parallel Function 800W Single Output With Parallel Function
【R7F0C809】LED finally flashes
I got the board half a month ago, and it was not until yesterday that I finally managed to light up the LED. What had been bothering me was that the system's built-in program would light up the digita...
wgsxsm Renesas Electronics MCUs
The p3.0 and p3.1 pins of 89S51 are used for RS232 communication. Can these two pins be directly connected to a computer? If not, do I need to connect a 232 interface chip between the computer and the pins?
The p3.0 and p3.1 pins of 89S51 are used for RS232 communication. Can these two pins be directly connected to a computer? If not, do I need to connect a 232 interface chip between the computer and the...
cln911 Embedded System
Circuit "integration" multiplies military power
Circuit "integration" multiplies military power. Since the advent of the first integrated circuit in the 1960s, microelectronics technology has developed rapidly in the past 30 years. It was first wid...
fighting Analog electronics
Usage of uc3875
I would like to ask all the experts, how should I connect UC3875 to output 4-channel fixed duty cycle PWM waves with dead zone and no phase shifting? I have tried various methods but there is no outpu...
_Mr.Q Power technology
Fuzzy control using a single chip microcomputer, who has tried it?
Fuzzy control is programmed with a single chip microcomputer. Has anyone tried it? Can anyone recommend some good information? Thank you!!!...
why_92 MCU
The third issue of New Year's Chip Coin Bidding - Book Bidding
[align=left][size=3][font=微软雅黑] brings you some technical books, some of which are donated to the forum by netizens. They are well preserved and new. Please reply and bid according to the letter numbe...
eric_wang Integrated technical exchanges

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 1779  1748  369  2209  1210  36  8  45  25  40 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号