(Half-wave pulse of sine wave: 11 ms; detection time: 10
µs.)
Min. 980 m/s
2
(Half-wave pulse of sine wave: 6 ms.)
Expected life
Electrical
Inductive load
10 to 55 Hz at double amplitude of 1.0 mm (Detection time: 10
µs.)
10 to 55 Hz at double amplitude of 1.5 mm
Min. 10
6
(at 180 times/min.)
Min. 3×10
4
(35 A 250 V AC) (ON : OFF = 1s : 9s) Min. 3×10
4
(48 A 250 V AC) (ON : OFF = 1s : 9s)
Endurance: 48 A 250 V AC (cos
φ
= 0.8),
Min. 3×10
4
(ON : OFF = 0.1s : 10s)
—
Overload: 72 A 250 V AC (cos
φ
= 0.8),
Min. 50 (ON : OFF = 0.1s : 10s)
Ambient temperature:
–50 to +55°C
–58 to +131°F
(When nominal coil voltage applied)
–50 to +85°C
–58 to +185°F
(When applied coil hold voltage is 50% to 60% of nominal coil voltage)
Humidity: 5 to 85% R.H. (Not freezing and condensing at low temperature);
Atmospheric pressure: 86 to 106 kPa
6 times/min. (at nominal switching capacity ON : OFF = 1s : 9s)
Approx. 80 g
2.82 oz
Conditions
Conditions for operation, transport and
storage*
4
Max. operating speed
Unit weight
Notes: *1. This value can change due to the switching frequency, environmental conditions, and desired reliability level, therefore it is recommended to check this with the
actual load.
*2. Wave is standard shock voltage of
±1.2×50µs
according to JEC-212-1981
*3. Coil hold voltage is the coil voltage after 100 ms following application of the nominal coil voltage.
*4. The upper operation ambient temperature limit is the maximum temperature that can satisfy the coil temperature rise value. Refer to Usage, transport and storage
conditions in NOTES.
*5. Release time will lengthen if a diode, etc., is connected in parallel to the coil. Be sure to verify operation under actual conditions.
Since the MCU does not support dual-edge sampling in SPI mode, and can only control the idle state of the clock line, but not the idle state of the data line (the first time it is high after configura...
[align=left][font=宋体]For the past 30 years, the industrial PC market has been dominated by x86 processors, which should come as no surprise given their use in desktop PCs. From fanless rugged box comp...
I bought the board when I just graduated from college, and soldered it myself. At first I didn't understand it and wasn't good at soldering. Later I learned how to debug and test points, and everythin...
[i=s] This post was last edited by paulhyde on 2014-9-15 03:42 [/i] Good information for students who are working on digital oscilloscopes. It starts with the indicators of the oscilloscope and gives ...
As the global industry demands electronic products to be "light, thin, short and small", the miniaturization of GPS systems has become a trend, and the size of GPS antennas has become a bottleneck in ...
The cleanest factory!Saudi Basic Industries Corporation (SABIC) has signed a major agreement to transform its polycarbonate plant in Cartagena, Spain, into the world’s first large-scale chemical produ...
At present, the traffic congestion in cities is quite serious. According to relevant news reports: In China, the traffic congestion has expanded from megacities such as Beijing, Shanghai, and Guang...[Details]
1 Introduction
With the acceleration of the pace of urban modernization, society has higher requirements for urban road lighting and urban lighting projects. The state has clearly required tha...[Details]
When choosing a laptop battery, you should consider several factors, such as power, appearance, and quality.
Regarding power, we often see that a manufacturer uses values such as the number ...[Details]
The data collector of the automatic weather station is generally designed based on a single-chip microcomputer or a PC/104 bus controller. It has the characteristics of good compatibility with PC, low...[Details]
Product series: PB-B-RS232/485 interface (hereinafter sometimes referred to as "interface") is a product in the PROFIBUS bus bridge series.
The main purpose of the bridge series ...[Details]
This week, Microsoft held its 2012 Microsoft Worldwide Partner Conference (WPC) in Toronto, Canada. At the conference, Microsoft showed its new products and services to partners around the world. A...[Details]
On the afternoon of July 10, Beijing time, Taiwan's largest chip designer MediaTek expects its smartphone chip shipments to grow by double digits in the third quarter of this year, and the company is ...[Details]
The automotive lighting and signal control system is responsible for controlling the vehicle's lighting, signal lights, electric horns, reversing and brake buzzers. Traditional automotive lighting...[Details]
The typical fault troubleshooting listed below is for reference of maintenance personnel.
When the computer is turned on, the indicator light is off and there is no screen display
Mainte...[Details]
With the advocacy and implementation of the government's Safe City Plan, the security market has increasingly higher requirements for the clarity of surveillance images. Imagine that after a case o...[Details]
The rectified DC voltage is then converted back to AC using power electronics such as insulated gate bipolar transistors.
The output voltage is switched on and off at a high frequency, control...[Details]
The above is to use MB1404 as a stereo composite signal transmitter. You can use the internal high-frequency amplifier and oscillator or not! According to my experience, I still recommend beginners...[Details]
0 Introduction
In order to improve the automation control of shortwave transmitters, so that they can automatically process from far to near, the technicians here use the ICS system to complete the ...[Details]
Cars equipped with xenon headlights are already common on the road. Whether they are standard equipment on high-end cars or embellishments on modified cars, xenon lamps are gradually becoming a sym...[Details]
The overall operating performance of an electric car depends first on its battery system and motor drive system. The drive system of an electric car is generally composed of three main parts: a con...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
