@@ VHDL@ Verilog Concise Chinese Tutorial [url=https://bbs.eeworld.com.cn/thread-74245-1-1.html]https://bbs.eeworld.com.cn/thread-74245-1-1.html[/url]@@ @@ For English, you can read the following two ...
I use the 2812 routine to debug the AD program. It works, but I can't get the correct result.I have the following questions:(1). When DEC2812 performs AD conversion, how should the input signal be con...
Generally speaking, the general image processing system is divided into four parts according to its functions: image acquisition part, image processing part, image display part, and image storage part...
I want to use the transistor "S8050" to amplify the current and control the relay (the relay's pull-in voltage is 3V and the current is 33mA). The output voltage of stm32 is 3.3V. How should I draw th...
Q: What comes with the lab circuit? A:Documentation (Circuit Notes)OperatingPrinciplesDesign PrinciplesTestDataCircuitEvaluation and Test Procedure*Common VariationsDesign Support Package*Schematic Di...
Emergency hand-held lamps powered by 6V maintenance-free batteries are widely used in rural areas. The charger used is a transformer step-down and single diode half-wave rectifier, and the charging...[Details]
Traditional broadcasting systems generally need to be operated manually at a fixed time, and can only realize one-way broadcasting with few functions. Traditional bell ringing equipment has a singl...[Details]
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
1. Circuit composition
The whole circuit consists of two parts:
1. Power saving control circuit
As shown in the figure below. Including delay circuit and drive circuit.
(1) Delay ci...[Details]
1. Introduction
With the growth of parking demand, the scale of parking lots is becoming larger and larger. A lot of research has been done on intelligent parking lots in China, but most of th...[Details]
Converged processors meet scalability requirements
In current embedded system design, solutions based on MCU, DSP, FPGA and ASIC account for more than 90% of the market share. These solutions ...[Details]
All electronic design engineers and scientists have performed electrical signal analysis, or signal analysis for short. Through this basic measurement, they can gain insight into signal details and...[Details]
System design is a complex process. It is not enough to just use ICs. There are many details to consider. This article uses a high-fidelity music playback system as an example to introduce how to s...[Details]
As cellular phones become more advanced, the power consumption of the system during operation and the power consumption during standby are also increasing. Therefore, the power management design of...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
1. Introduction
At present, most lighting equipment still uses traditional energy for lighting. Making full use of solar energy as the energy supply for lighting equipment is of great si...[Details]
Vertical cavity surface emitting lasers (VCSELs) are gradually replacing traditional edge emitting lasers, especially in low bandwidth and short-distance communication systems where cost factors ar...[Details]
1. System Structure
This system is a simulation system of indoor air-conditioning temperature/humidity control system. The data acquisition and control center collects temperature/humidity...[Details]
Overview:
This paper introduces a method of connecting a CAN-bus network with Ethernet to form a medium-sized remote monitoring/data transmission network.
CAN (Controller Area Network) is ...[Details]
FPGA/CPLD
京公网安备 11010802033920号
EEWORLD
