PTN2512K3441BBT0

1. Principle 1. Infrared emission protocol The infrared transmission protocol has been written in the previous article , so I will not repeat it here. 2. Timer counting and input capture A timer...[Details]

1. Problem When developing STM32 with IAR, I found that I could not print floating point numbers by redirecting printf to the serial port. The code is as follows:  The output is as follows:  It can...[Details]

The adoption rate of serverless cloud computing is gradually increasing, but it has not yet reached people's expectations. Various surveys show that serverless is still an eme...[Details]

Different from 51, AVR and other single-chip microcomputers, the clock signal sources of msp430 include LFXT1, XT2 and DCO. 1. LFXT1: It can connect high-speed and low-speed crystal oscillators. In l...[Details]

In the project, CPLD is needed to complete part of the algorithm design. The parameters are given by AVR, so the communication between AVR and CPLD needs to be completed. Therefore, a test program is...[Details]

What is SYSTICK: This is a 24-bit system tick timer, SysTick, with automatic reload and overflow interrupt functions. All microcontrollers based on the Cortex_M3 processor can obtain a certain time ...[Details]

Independent watchdog (IWDG) and low power mode are often used in STM32 development. The watchdog is to detect and solve faults caused by software errors, and the low power mode is to enter sleep mode...[Details]

STM32 has two watchdogs: independent watchdog and window watchdog. This article mainly introduces the use of independent watchdog. Independent watchdog (IDWG): driven by an independent 40KHZ low-sp...[Details]

;Question: The 80C51 single-chip microcomputer has a fosc = 6MHz. It is required to use the T1 timer working mode 1 to perform a timing of 40ms. And P1.7 periodically outputs a rectangular wave with ...[Details]

Design a program for the 51 single-chip microcomputer. It is known that the crystal oscillator frequency of the 89C51 single-chip microcomputer is 12MHz, and it is required to use T1 timing to output...[Details]

#include "MSP430x24x.h" void main(void) {         // Stop watchdog timer to prevent time out reset         WDTCTL = WDTPW + WDTHOLD; //Watchdog            P4DIR = BIT0|BIT1|BIT2|BIT3; //Set to outpu...[Details]

/********************************************************************** **                                                        ** File : EEPROM.c | Eeprom write and read |                         ...[Details]

Homemade LED Electronics   Clocks can be seen in many electronic newspapers and magazines, but most of them need to reset the time and other parameters after power failure, which brings a lot of inco...[Details]

#include "MSP430x44x.h"  void init_UART(void);  void uart_start(void);  void uart_send(void);  void uart_receive(void);  unsigned char RXDATA_BUF ,TXDATA_BUF ={0xbd,0x77,0x3d,0xc5,0xc6,0xf5,0x68,0x0d...[Details]

The Arctic region has always been cut off from the outside world, and if oil workers and polar expedition personnel are in danger, they need robots to provide rescue work. Sergey...[Details]