After positioning the STP model in PCBLIB, how can I lock the STP position to prevent it from being moved in the PCB? I have aligned the pins with the pads, how can I lock the position between them? I...
Rockchip launches RK2808 chip solution for 720p playback under Android. Fuzhou Rockchip, the strongest domestic chip solution manufacturer, has just launched the RK2808 chip solution, which is a chip ...
Dear experts, when I do the CAN1 loopback test, I can send and receive data normally; but when I change to normal mode, I cannot send and receive; CAN2 loopback mode and normal mode cannot send and re...
Abstract: The demand for dynamic power management in embedded systems is analyzed , and on this basis, a system-level dynamic power management architecture based on a policy framework is proposed to a...
Gesture sensor
1. The difference between attitude sensor, gyroscope, acceleration, angular velocity and geomagnetic sensor
2. The difference between 3-axis, 6-axis and 9-axis gyroscopes...
[i=s] This post was last edited by fengye5340 on 2014-7-9 13:49 [/i] [align=left][b][size=4]1. Solution introduction: [/size][/b][/align][align=left][size=4] In the 24V powered BLDC driver application...
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
introduction
For the voltage regulator modules (VRMs) that power the latest computer central processing units (CPUs), power supply designers have historically used multiphase interleaved b...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
1. Introduction
Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]
The DisplayPort interface standard is approved by the Video Electronics Standards Association (VESA) to provide an open, scalable standard for the entire industry. The development of DisplayPort ca...[Details]
1 Embedded Systems
Embedded System refers to a collection of computer hardware and software with specific functions or purposes, which is divided into embedded software system and embe...[Details]
Every time I go home and walk up the stairs, I am always scared. The corridor lights are often broken, and no one changes the bulbs, or they are not smart enough and need to be operated manually. E...[Details]
The most important components of new energy electric vehicles are power batteries, electric motors and energy conversion control systems. The power battery must achieve high performance such as fas...[Details]
The capacity of a battery depends on the amount of charge and discharge, in addition to some factors of the battery itself. Obviously, if the charge and discharge of the battery can be recorded all...[Details]
Multimedia processors are often the most power-hungry devices in portable electronic devices. Common ways to reduce CPU power requirements are to reduce clock frequency or operating voltage, but th...[Details]
As a new type of centralized and decentralized elevator control system, serial communication has been widely used in China. Compared with the previous centralized and unified control system, each s...[Details]
0 Introduction
The load with impact (rapid change) power in the power system will cause the voltage fluctuation and flicker of the power grid, causing many electrical equipment to fail to wo...[Details]
In the 1980s, breakthroughs were made in the design and production of small, low-power quartz metal halide lamps with precise dimensions. At the same time, with the acceleration of people's lives a...[Details]
High specific energy lithium/thionyl chloride (Li/SOCl2) batteries are widely used in multi-functional intelligent meters (such as smart meters, water meters, etc.) as real-time clocks and memory b...[Details]
Reliability and real-time performance are the basic requirements for control systems. Initially, motor control used analog circuits with discrete components. With the advancement of electronic tech...[Details]