Training

Location:Training / Hot Applications / Wireless Communication / Principles of Communication (Beijing University of Posts and Telecommunications, under update) / Introduction to stochastic processes

You can log in to your eeworld account to continue watching：
Introduction to stochastic processes
Login

Duration：44 minutes and 21 seconds
Date：2018/06/01

Uploader：量子阱

Introduction

keywords：

"Communication Principles" is a core professional basic course for electronic information related majors. This course introduces the general principles of information transmission at the physical layer, that is, the basic principles and related methods of how to achieve information transmission with the help of electrical signals. The content of this course mainly includes: deterministic signal analysis, random signal analysis, analog sinusoidal modulation, digital baseband and frequency band transmission, signal sources, etc. This course is an introductory course in communications, focusing on basic principles and theories, laying a solid foundation for further study.

Teaching videos related to Beijing Postgraduate Entrance Examination Subject 801

Supporting textbooks: Principles of Communication, Third Edition, Zhou Jiongpan, Pang Qinhua, Wu Weiling, Yang Hongwen, Beijing University of Posts and Telecommunications Press

You Might Like

Recommended Posts

[ESP32-Audio-Kit Audio Development Board Review] SD Card Reading and Writing: The audio development board is equipped with a TF card interface, which can read and write TF cards under the control of the program. The interface circuit and physical state of the TF card are shown; jinglixixi RF/Wirelessly

The result of MSP430 Launchpad DS18B20 program is always 0. I am very frustrated and need help.: The code is as follows: ******************ds18b20.c*************** #include#include "1602.h" #include "ds18b20.h" #define DQ1 P2OUT |= BIT3 #define DQ0 P2OUT = ~BIT3 uchar table[4]; /*****************; binghuojxj Microcontroller MCU

Question about 2440 interrupt rate?: 2440 has a 250KBPS communication device, which generates about 2272 interrupts per second. If the interrupt pin is connected to EINT17, 2440 cannot respond in WINCE and often loses interrupts. If the; flyactel Embedded System

Precautions when using pull-up resistors on GPIO ports: I just started learning. I spent an afternoon experimenting with the GPIO port of the MSP430 launchpad. As a result, the port did not work after setting it. Later, I read the datasheet and fixed it. R; flyword Microcontroller MCU

Wide VIN DCDC Power Solution: [i=s]This post was last edited by dontium on 2015-1-23 11:34[/i] This document introduces the solution provided by Texas Instruments for wide VIN DCDC power supply.; 德州仪器 Analogue and Mixed Signal

Interrupt handling issues: When the interrupt valid level is triggered by the rising edge, when an interrupt occurs, how to save and clear the flag from the hardware perspective?; zw357234798 FPGA/CPLD

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号