• You can log in to your eeworld account to continue watching:
  • The response of some typical signals through the system, as well as a summary of the time domain solution method
  • Login
  • Duration:6 minutes and 11 seconds
  • Date:2018/09/04
  • Uploader:老白菜
Introduction
Through the study of this course, students should be able to master the basic theories and methods of signal analysis, master various description methods of linear non-time-varying systems, master the time domain and frequency domain analysis methods of linear non-time-varying systems, and master relevant Some important conclusions in engineering applications such as system stability, frequency response, and causality. At the same time, through the study of this course, students' ability to analyze problems and use the knowledge they have learned to solve problems should also be improved on the original basis. Through the study of this course, students can lay a good foundation for further study of signal processing, network theory, communication theory, control theory and other courses in the future.
Unfold ↓

You Might Like

Recommended Posts

Questions about STM32pendSV
I want to try DIY RTOS on STM32 recently.PendSV is used to complete task field switching.The problem now is that when running by software simulation, the pendSV exception service can be executed immed
wowow stm32/stm8
Questions about curve fitting using Verilog
Regarding using Verilog to perform curve fitting, the data source is a set of measured pressure sensor data, and the requirement is to fit it using the Verilog language. The question is: Verilog is a
eeleader-mcu FPGA/CPLD
Implementation of LM3S811+NRF24L01
Use the SPI port of LM3S811 to connect NRF24L01 and UART1+UART2 to configure as RS232 and RS485 communication ports respectively. The serial port baud rate is 115200 8_N_1 configuration, which can rea
bjmonsoon Microcontroller MCU
[National Technology N32G457 Review] RT_Thread Studuio SPI data transmission failed
[i=s]This post was last edited by lugl4313820 on 2022-2-6 23:14[/i][National Technology N32G457 Review] SPI Transceiver Review - Domestic Chip Exchange - Electronic Engineering World Forum (eeworld.co
lugl4313820 Domestic Chip Exchange
How to define global variables in Keil C that can be used by all files in a project?
As the title says --------------------------- How can I define a global variable in Keil C that can be used by all files in a project? I want to define a variable in a .c file, and then use this varia
xioajinglchy Embedded System
How to set the GND pin of a separate component as a flower pad in PADS?
Hello to all great gods! How can I set a separate component ground GND pin as a flower pad in PADS? Or can it be done in the packaging? Thanks!
蓝天007 PCB Design

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号