Training

Location:Training / Embedded Development / MCU / Punctual Atomic teaches you step by step how to learn STM32-M4 / IO pin multiplexing and mapping

You can log in to your eeworld account to continue watching：
IO pin multiplexing and mapping
Login

Duration：19 minutes and 13 seconds
Date：2019/03/21

Uploader：EE大学堂

Introduction

keywords： Microcontroller STM32 Punctual Atom

This video will lead you from the basic to the more advanced to learn the various functions of STM32F4 and start a new STM32 journey for you.
This video is divided into three parts:
1. Introductory part, which mainly introduces the basic knowledge of STM32;
2. Intermediate part, mainly introduces the use of STM32 basic peripherals, including: GPIO, serial port, timer, external interrupt, etc. After studying this article, you will have a basic introduction to STM32 development.
3. Advanced chapter, mainly introduces STM32 advanced peripherals, including: SDIO, CAN bus, etc.

You Might Like

Recommended Posts

Philips introduces microcontrollers based on the ARM9 series: Philips introduces microcontrollers based on the ARM9 series; maker MCU

The simulation of multiplication floating point IP in quartus, has anyone used it?: Help, help!! I use Modelsim to simulate the floating point multiplier ALTFP_MULT in Quartus. Why can't I get the expected result? I'm new here, thank you all in advance~; QiuQiuX FPGA/CPLD

What should I learn about analog electronics?: When I first learned analog electronics, I was confused. I took a week off and went through it again. I only looked at the small signal amplification part. I feel that analog electronics is easier to; 飞鸿浩劫 Analog electronics

8-bit DA TLC7524 application and software design issues: [i=s]This post was last edited by paulhyde on 2014-9-15 03:02[/i] I am now using MSP430F149 to make a digitally controlled constant current source. The AD uses the 430 internal ADC12, and the DAC uses; f166783980 Electronics Design Contest

MCU external interrupt: Configure external interrupt 0 to be triggered by the falling edge to count the external pulses. However, when I tried it with a button, several pulses were added, and some even counted more than 20.; 鹏怜鸿影 51mcu

The development board serial port 1 cannot be used? ?: My board is s3c2410a, which has two serial ports. One is uart0 for connecting serial devices and outputting debugging information, and the other is uart1 for connecting serial devices. However, after; zdk Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号