• You can log in to your eeworld account to continue watching:
  • Digital and modern communication systems
  • Login
  • Duration:25 minutes and 44 seconds
  • Date:2019/03/24
  • Uploader:JFET
Introduction
This course mainly studies the working principles and composition of each unit of sending and receiving equipment in communication systems, as well as the working principles, typical circuits and analysis methods of various unit circuits that constitute sending and receiving equipment. It should be noted that in nonlinear electronic circuits, in order to achieve the same function, different circuit forms are used due to different index requirements. In addition, even if the circuit is of the same form, if its working status, input signal properties, level, output filter characteristics, etc. are different, the functions implemented will be different. Therefore, we must pay attention to mastering the basic principles of various functional circuits, the characteristics and applicable occasions of different circuits, and grasping the internal connections and commonalities of each functional circuit.
Unfold ↓

You Might Like

Recommended Posts

Transistor problem
A signal of about 8M passes through C11 and the transistor. The 8M signal is generated by a capacitor three-point oscillation circuit, passes through C11, and then is amplified by the transistor. How
S3S4S5S6 Analog electronics
【AT-START-F425 Review】Using the USB flash drive file storage function to achieve data recording
Previously, we introduced how to use the USB flash drive file reading function to realize the digital photo frame function. This time, we will talk about using the file storage function to act as a da
jinglixixi Domestic Chip Exchange
Lingyang launches LIN node solution based on 16-bit MCU SPMC75
(2006-01-07 08:51:46 )Sunplus Technology (SUNPLUS) recently announced the launch of a LIN node application solution based on the 16-bit microcontroller SPMC75. LIN (Local Interconnect Network) is a lo
fighting MCU
What are the problems with swapping the AC input live and ground wires?
I first accidentally discovered that the power board was not working properly. The output was not 15V, but about 2-3V. After checking, I found that the live and ground wires of a power cord were conne
ldsheng Power technology
Provide application program interface and write product SN
Provide a method for the application to write the product SN to the flash. Can you give me some suggestions on what is a feasible method? . .
asqw Embedded System
How to set AD654 (V/F conversion) to make the input voltage range suitable for 0~5V
Generally, when the power supply voltage is +5V, the input requirement is 0~1V. How can I make the input 0~5V also possible? Should I adjust the size of Rt?
bbslb Embedded System

Recommended Content

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号