• Duration:25 minutes and 57 seconds
  • Date:2020/07/27
  • Uploader:抛砖引玉
Introduction
This course combines previous competition questions, starting from a practical perspective, dismantling the question requirements, analyzing the test points of the competition questions, including a full set of design steps from problem analysis, device selection, parameter design to circuit optimization, and explaining in detail the electronic competition questions. Important knowledge points to help everyone lay a solid foundation and make more substantial preparations for the e-sports competition.
Unfold ↓

You Might Like

Recommended Posts

The Forbidden Fruit and Flower: The Last Judgment: The Ultimate Exploration of the Truth of the Human World
If I lose, I am no longer afraid; If I can get, I will treat it as fireworks; Who is Eve who cannot afford to eat the forbidden fruit? Who is still confusing me and won't give up? I can't remember wha
renzaisina Integrated technical exchanges
[Ask TI] Does TI have any recommendations for front-end circuit chips with high sampling rates between 500M and 1G?
[i=s] This post was last edited by dontium on 2015-1-23 13:34 [/i] Recently, a project requires a sampling rate of 500M~1G. Does TI have good AD and high-bandwidth FET op amps? Introduction to program
梦之旅 Analogue and Mixed Signal
Please recommend a dedicated IC for controlling thyristors
1. COMS technology, micro power consumption device, 2. Contains voltage zero-crossing detection function, 3. Large output drive capability, 4. Output is a pulse wave with adjustable pulse width, (Afte
harris Analog electronics
How does an infrared thermal imager work?
Fluke Infrared Cameras operate on the principle of infrared thermal imaging. Thermal imaging is often used as a cost-effective inspection tool for diagnosing, maintaining and inspecting electrical sys
微微笑1324 Integrated technical exchanges
Can I use 4 FR107s to rectify AC220V?
It is easy to burn out if you use 1N4007!
dianzijie5 Power technology
atmega16 interrupt is running wrong, can you help me solve it?
Hello everyone, here is a program I wrote to realize that when external interrupt 2 is triggered, the motor moves forward. Why does it jump into external interrupt 0 every time an external interrupt c
wuyiliwenjie Microchip MCU

Recommended Content

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号