When the feedback loop is disconnected, Ui increases and the voltage at the upper end of C1 decreases. Why does the voltage at the lower end of C2 increase?
The GE PAC7I product used online has the same problem twice recently: remote I/O has no output, the CPU has no faults in the fault table and is also displayed in RUN state, but there is LOSS OF IOC in
I bought a touch screen with ILI9320 controller, the touch chip is ADS7843I used to use 12864 LCDs, but I found that the touch screen is a bit difficult. It's a PDF of the ILI9320 controller and it's
My IAR version is IAR Assembler for MSP430 5.30.1. It says that this version uses MSP-FET430UIF and does not require the installation of drivers. It comes with the internal folder.I can download progr
ULP Wireless Quarterly takes a closer look at NORDIC products and their applications. For 20 years NORDIC has been focusing on ultra-low power wireless communications below 1 GHz and 2.4 GHz , making
Using a development board based on SIMCOM300, I use the HyperTerminal to operate the target board. Using COM3, whether or not the development board is connected with a serial cable, sending AT will re