Training

Location:Training / Embedded Development / Understand the mysterious face of uboot / The second half of board-level initialization: bord_init_r function analysis 2

You can log in to your eeworld account to continue watching：
The second half of board-level initialization: bord_init_r function analysis 2
Login

Duration：21 minutes and 59 seconds
Date：2021/10/15

Uploader：抛砖引玉

Introduction

keywords： Linux uboot

The purpose of this "Understanding the Mysterious Face of Uboot" course is to help you understand the concepts and related hardware involved in the system startup part of embedded development step by step through the analysis of the entire process of an excellent bootloader software. principle. Including CP15, UART, DDR2 and other device information that must be mastered for system startup.

You Might Like

Recommended Posts

There are many "tools" that are not fully understood.: There are many "devices" that I haven't understood thoroughly. Phase-locked loop PLL, voltage-controlled oscillator VCO, low-pass filter LPF, high-pass filter HPF, adder, subtractor, multiplier, divid; QWE4562009 Discrete Device

The output image flickers severely after DSP processing: I use a Hezhongda test box, the DSP model is DM643. I originally used a routine program to perform simple image processing, and the picture was very good. But later I transplanted some OpenCV code int; yejing2008 Embedded System

Designing Precision Power Supply with the Attitude of Treating Signals: [size=5][color=#ff0000][font=宋体]I saw a[/font][font=宋体]graduate student in a university's optical access network laboratory's experience in making power supplies, so I'd like to share this with you, h; qwqwqw2088 Analogue and Mixed Signal

One disadvantage of multi-layer circuit board design: 1. Plating copper over a large area is not necessarily good. In a series circuit, the current is equal everywhere. If you just widen and thicken the ground copper, the interference of heat dissipation; jinpost MCU

How to enter IDLE mode in wince5.0: Can anyone tell me which functions should be implemented to enter IDLE mode in WINCE5.0? My S3C2440 BSP contains OEMIDLE() and OALCPUIDLE() functions, and OALTimerUpdate() is also used in OEMIDLE(), b; onlinesh Embedded System

When porting ucosii to MSP430F2418, the created task does not run: [i=s]This post was last edited by adam_zhang41 on 2015-8-19 16:53[/i] Recently, I found a ucosii that someone else had already made on the Internet and transplanted it to MSP430F2418. I created a task; adam_zhang41 Real-time operating system RTOS

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号