Training

Location:Training / Tools/EDA / Digital VLSI Design (RTL to GDS) / 2c_ Simple Verilog Examples

You can log in to your eeworld account to continue watching：
2c_ Simple Verilog Examples
Login

Duration：14 minutes and 40 seconds
Date：2024/05/04

Uploader：抛砖引玉

Introduction

keywords： VLSI

Bar-Ilan University 83-612: Digital VLSI Design

In this course, I cover the basics of Chip Implementation, from designing the logic (RTL) to providing a layout ready for fabrication (GDS).

Lecture slides can be found on the EnICS Labs web site at:
https://enicslabs.com/academic-courses/dvd-english/

You Might Like

Recommended Posts

wince message passing problem! Thank you: I wrote a function to send messages. It is just a function. An array is defined in this function. So is this array stored in the stack? After calling this function, the array will be cleared! At this; ababab Embedded System

Does anyone have the Chinese version of Windows Automotive 5.0 UI Toolkit?: I am a rookie who has just joined the embedded development, I hope you can give me help! ! ! ! ! ! ! !; 慕梓想 Embedded System

I have some questions about CORTEX-M TARGET DRIVER SETUP.: I have some questions about CORTEX-M TARGET DRIVER SETUP. Please help me. As shown in the figure below 1. What is the difference between full chip and sectors in 1? Where do I specify which sectors? 2; 深圳小花 MCU

Quartus II 9.1 pin locking problem: I wrote a latch program, the program is as follows: module suocunqi1(LO,IN,LT);input[3:0] IN;input LO;output[3:0] LT;reg[3:0] LT; always@(posedge LO)begin LT=IN;endendmodule I am going to use EMP7128; coney FPGA/CPLD

[Repost] Effective countermeasures for PCB process film deformation: [font=Microsoft YaHei]In the PCB copying process, the failure of temperature and humidity control or the excessive temperature rise of the exposure machine sometimes causes the film to deform. If it i; 皇华Ameya360 DIY/Open Source Hardware

About the power supply problem of LM741 op amp: I am upgrading an instrument that someone else made before. The 741 used in the instrument is powered by positive and negative 15V. Now I want to use positive and negative 5V power supply. Is it enoug; mytzh Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号