Training

Location:Training / Webinar / Live Replay: Microchip uses motorBench® Development Kit to efficiently develop motor field-oriented control solutions / Efficiently develop motor field-oriented control solutions using the motorBench® development kit

Chapter 1：Efficiently develop motor field-oriented control solutions using the motorBench® development kit

Duration：36 minutes and 35 seconds
Date：2025/03/25

Uploader：hi5

Introduction

keywords： Microchip motorBench Motor magnetic field Directional control

The motorBench® development kit is a graphical software development tool launched by Microchip specifically for field-oriented control (FOC) solutions. It can accurately measure key motor parameters within a certain range, automatically generate feedback control loop gains, and generate engineering source code based on the MCAF (Motor Control Application Framework) architecture. The test component test-harness provided by the motorBench software can put the controller in test mode to test the frequency response characteristics of the system and adjust the PI parameters to appropriate values in a very short continuous interval. The tool allows users to reconfigure hardware peripherals and perform code migration between different devices. Users can use these features to significantly improve development efficiency.

You Might Like

Recommended Posts

Filter function judgment: Determine what function the signal output in the figure implements (high pass, low pass, band pass, etc.) Uo1 is low pass, Uo2 is band pass, Uo3 is band pass; how do you tell? It's a bit hard to tell; 1nnocent Analog electronics

Solar powered circular aircraft: [img]http://www.diytd.com/uploadfile/20070410140756724.jpg[/img] The "Solar Circular Plane" I designed and made uses solar energy as its energy source to simulate an airplane flying around the earth i; yuandayuan6999 Energy Infrastructure?

I would like to ask how to store the data received by the STM32 DMA serial port into an array and then send it out through the serial port. Thank you.: int main(void) {SysTick_Config(SystemCoreClock/1000);LCD_Port_Init(115200);while(1){if(RxOverFlag2 = 1){USART_SendString2(USART_RXBUF);USART_SendString3(buzzer);}} }/*函数名称：DMA_Configuration2函数用途：STM32; 小子不乖1229 Embedded System

Can anyone recommend some good tutorials?: rt; 瓜妞妞 Embedded System

I recently made a PCB and used PADS to simulate it, but the actual board didn't look good.: I recently made a PCB and used PADS to simulate it. The actual board effect is not good. I will find a more accurate simulator.; kata PCB Design

Where are we, the 2009 graduates heading to?: The economic crisis and the world recession. Where should we, the 2009 graduates, go? There are many different opinions. In short, the fact is: the employment situation of 2009 graduates is grim. Take; 瞿志鹏 Talking

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号