• You can log in to your eeworld account to continue watching:
  • Fundamentals of Digital Electronics Technology 23
  • Login
  • Duration:45 minutes and 24 seconds
  • Date:2014/01/01
  • Uploader:EE资深网友
Introduction

Produced by the School of Electrical Engineering and Automation, Harbin Institute of Technology, "Fundamentals of Digital Electronic Technology", lectured by: Wang Lixin


This basic digital electronic technology tutorial from Harbin Institute of Technology introduces the basics of digital circuits, logic gate circuits, logic algebra, analysis methods and design methods of combinational logic circuits, application of combinational logic circuits, flip-flops and timers, etc.

Unfold ↓

You Might Like

Recommended Posts

How to boot kernel with uboot
I compiled uboot and found that the problem was with the cross compiler. Fortunately, it was over and I started to boot the kernel. I looked at the uboot code and found no information about the nand f
zengjiangyi Embedded System
Some problems in the 4511 decoder!
I recently designed a buzzer, but I can't figure out some problems! I know there are many experts in our forum, so I'm here to ask for advice! I need to connect a seven-segment display to the back of
fsunboy Embedded System
How is the 64-bit MAC address of the CC2530 device selected?
There are two IEEE addresses in CC2530/CC2538/CC2630, one is called Primary IEEE address, the other is called Secondary address. Primary IEEE address is stored in Information Page of chip, this addres
灞波儿奔 RF/Wirelessly
Look at the burned LM2596
Today, the company returned several devices for repair. All of them were LM2596s that burned. This one burned the most severelyThis one is betterThis one didn't burn, but a leg fell offLet's analyze t
jishuaihu Power technology
CH554 Review: DIY Digital Thermo-Hygrometer and Review Summary
I have basically completed the evaluation of CH554T, and finally ended the evaluation with a simple DIY. Hardware: CH554T evaluation board, DHT11 sensor module, LCD5110 liquid crystal module Function:
zhang7309 MCU
See the picture above for help
As shown in the figure, the required output SPWM1 signal does not exist in MODELSIM. Thank you.
jinheng23 FPGA/CPLD

Recommended Content

Hot VideosMore

Hot ArticlesMore

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号