sigma

OpenBCI Daisy

Overview

A clone project from the well-known open source project OpenBCI Daisy, most of which were replaced with original parts from Lichuang EDA, and some details of the design were changed. The board shape was changed from similar to a hexagon to a rounded rectangle, which increased the area of the circuit. .

Original project introduction:

# OpenBCI Daisy Hardware Design Files

You should have received a copy of the license information for these Open Source hardware files. We are licensing under the [CC-BY-SA 4.0 License](http://creativecommons.org/licenses/by-sa/4.0/legalcode) . You should also have downloaded the Design Spark Library files in this directories parent. To get setup with the Design Spark software, go [here.](https://github.com/OpenBCI/V3_Hardware_Design_Files/blob/master/README.md )

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-23 20:29:05

The LCD screen does not display the desktop after the system starts
The PXA270 development board, the original system was normal, but there was a problem with a solder joint of the LCD screen, and the LCD screen kept flickering. After the boss took it away and re-sold
Problems with nios ii SPI slave mode
I need to connect two boards for SPI communication, so I created a Nios processor with slave mode SPI. After downloading the sof file into the board, as long as I connect the wires to the three GPIO p
Display Problems When Using MCU Serial Port Interrupt and Timing Interrupt Simultaneously
#include#include#define uchar unsigned char #define uint unsigned int sbit RS = P3^5 ; sbit RW = P3^6 ; sbit EN = P3^7 ; sbit BUSY = P2^7; sbit LED = P0^0; sbit zhendong = P0^1; sbit spk = P0^2; sbit
DIY-Small Stool (First Work)
[color=#ff0000][size=5]Today's post has nothing to do with electronic technology, but it has DIY significance! [/size][size=5] [/size] [size=5]I like DIY very much, especially in electronics, machiner
Can't access the Internet after setting CMWAP in WINCE!
Hey everyone: I have completed GPRS dial-up Internet access on WINCE5. When the APN is set to CMNET, the Internet access is normal, but when it is set to CMWAP, the system's built-in IE (IESAMPLE) see
51 MCU timer time setting problem
I would like to ask how to use the timer interrupt settings when developing for 51 microcontrollers in Keil's C language. My program is as follows: [code] #include I would like to ask, if I use a 11.0

Datasheet More

Circuits More