eDPSTpY2M

18b20

Overview

18B20 interface board, the size of a single small board is about 1.2*1.2cm. Because I didn’t pay attention when putting together the boards, the silk screen numbers automatically increased.

The materials required are: 3pin header, temperature sensor 18B20, 4.7k resistor.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-19 12:38:48

Use C language to classify and read files in SD card (Linux platform)
For example, read the MP3 files in the SD card and generate a file list. Thank you
Accuracy of MSP430 built-in temperature sensor
The nominal 00C voltage and temperature coefficient with the corresponding tolerance range are provided in the datasheet. The nominal 00C voltage is specified as 986mV with a maximum error of +/- 5%.
Learn how to burn Ubuntu system on 4412 development board
[b][font=微软雅黑][size=10.5pt]This article is reproduced from Xunwei:[/size][/font][size=14px][url=http://www.topeetboard.com][u][color=rgb(0, 0, 255)][font=宋体]www.topeetboard.com[/font][/color][/u][/url
WinCE 6.0 uses TTS
I am a beginner in wince. I want to use TTS to realize voice in wince6.0. After I customized the system and wrote a test program with TTS and copied it to wince, it prompted that COM could not be foun
AVRUSB+ADC
The following is the newly completed AVRUSB-ADC conversion. The relevant introduction is as follows: 1. The circuit is slightly modified based on the original USBASP 2. Driver, if you have already ins
Calculation Problem of Quality Factor of Low-pass Filter Circuit
As shown in the figure, it is a screenshot from a post by gmchen on active filters and low-pass filters. For the second-order low-pass filter circuit shown in the figure, how is the quality factor Q i

Datasheet More

Circuits More