Fg9aP5

PIC (16F877A) development board

Overview

A development board that is of no use and is just a boring thing to draw.
The AD file is attached.
The board size is within 10*10.
The board has not been tested and any problems will be corrected promptly.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-23 15:16:26

How to use .net compact framework2.0 of vs2005 to develop Wince program? Urgent!
I developed a WinCE project with vs2005, which can run on a PC, but when I put it on the development board, I get a Not Supported Exception when I run the program. I used a generic class List<>, which
stm32 rtc (transfer)
1: For 32768HZ crystal, any 6pF--12.5pF is fine (except for those with quality problems), not the legendary beast. 2 (Important): At least one ceramic capacitor (100nF X7R dielectric material) must be
Is there any way to tell that the USART is sending a byte?
When I say "transmitting", I mean data is being shifted out on the TXD pin.There doesn't seem to be a bit in the status register that represents this state.
ARM Embedded System Design Basics Tutorial Courseware
ARM Embedded System Design Basics Tutorial Courseware
How to measure resistance on the road
I soldered a 15K chip resistor on the circuit board. After the circuit ran for a while, I measured the resistance in a short circuit and found that the resistance value became 3.6K. I don't know what
Is the electromagnetic radiation from the job of wireless engineer serious? Is it very harmful to the body?
Are the electromagnetic radiations of antenna engineers, RF engineers, debugging engineers, and EMC engineers serious? Are they harmful to the body?

Datasheet More

Circuits More