qvg7SG4

#The 7th Lichuang Electric Competition# Ammeter - Development Board

Overview

1. Introduction to project functions
Function 1: Amperemeter function
Function 2: Development board (for learning)
(no link function, you have to pay extra to buy it haha)

2. Project attributes
The project is open source for the first time 4. See the engineering drawing below for

the hardware part * 8. Demonstrate your project and record it into a video and upload it. For more details: https://diy.szlcsc.com/posts/d76d9cb41705430e9a54e7a5feed07a5

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-15 03:13:28

LTE TURBO Coding Documentation
Documentation for LTE TURBO coding is urgently needed
stc89c51 drives transistor as switch circuit
I used the IO of stc89c51 to generate a square wave with a high level of 5v, a low level of 0V, and a duty cycle of 1kHZ and 80%, and then connected the IO to a transistor (as shown in the figure) to
How should I modify the SDHC driver in the BSP to support multiple SD devices? Please give me some ideas.
The existing BSP only supports one SD card. (Question 1: Generally speaking, the CPU should be able to support multiple SD cards physically, and it should have relevant registers to indicate the numbe
How to modify the default value of protel99sePCB toolbar?
I am a beginner. When I draw a PCB board, the default values of the tools on the toolbar are all large. How can I make them smaller? Please help!
Address bus programming problem
I am now going to write a program for the address bus of arm9 (YC2440) to achieve the function of transmitting data to another board. I wonder if anyone has done it before? Or is there any information
XMC4800 Relax ECAT Kit Review 3 - Testing the EtherCAT Slave
[i=s]This post was last edited by tdatd on 2019-1-8 08:23[/i] After setting up the environment and lighting up the LED, we will go straight to our goal - ethercat communication. We will start the test

Datasheet More

Circuits More