蓝猫淘气

NCV51511SYNCBUCKGEVB：NCV51511 EVAL BRD

NCV51511SYNCBUCKGEVB: NCV51511 EVAL BRD

Overview

The Evaluation board is developed to evaluate performance of high side and low side gate driver and the target application is 300W non-isolation Synchonous Buck 48 V ±10% input voltage and 28 V regulated output voltage.
To supply bias voltage both synchronous buck and NCV51511, the NCV33163 control the auxiliary power output around 10 V. And the main synchronous buck controller generate high side and low side PWM input signal for NCV51511.The NCV51511 drive the high side and low side external MOSFET depend on the input PWM signal and VDD level.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-07 10:41:04

How to operate sqlce when developing wince5.0 program with vs2005 (C++)
How to operate sqlce when developing wince program with vs2005 (C++)? Without using CF. The information I found on the Internet either uses evc and adoce, but it cannot be compiled under vs2005; or us
Please help me, heroes!!!
I just learned zigbee and got a set of equipment. When I was doing the experiment of two indicator lights flashing alternately, the indicator light of the module did not respond at all. I did this exp
Please help me with the slides and lecture notes
I recently watched a video training of C2000concerto, which mentioned that there are slides and lecture notes. I wonder where I can find them? If anyone knows, please tell me. Also, if anyone has rele
spi3 problem with stm32
First of all, the board I use is the stm32f103zc series. Regarding this chip, there is an example of spi full-duplex communication in the st official library. According to my analysis, this example is
A process of designing SC16IS752 board using KiCad
After the completion, the 3D schematic diagram sent for proofing is as follows:When I was almost done yesterday, I found that the layout was not right:In the above layout, the signal line is long, and
Question: I defined a global variable in src/common/intr.c to save the interrupt number. How can I reference this variable in my own driver?
I want to write a keyboard driver. First, I define a global variable "volatile UINT32 g_keyIntIrq" in src/common/intr.c to record the pin where the interrupt occurs. How can I use this variable in my

Datasheet More

Circuits More