sigma

NCV7544VTFS5C466GEVB: NCV7544 FLEXMOS™ Quad Half-Bridge MOSFET Pre-Driver Evaluation Board

NCV7544VTFS5C466GEVB: NCV7544 FLEXMOS™ Quad Half-Bridge MOSFET Pre-driver Evaluation Board

Overview

The NCV7544VTFS5C466GEVB is designed to quickly evaluate the NCV7544 Quad Half-Bridge pre-driver. The design demonstrates a full application incorporating: WDFN8 (µ8FL) MOSFETs, a microcontroller, 5 V voltage regulator, current-sense amplifiers, controls and USB interface. The board is intended to provide quick and convenient means for evaluation of NCV7544 application either standalone, controlled from a PC or by an external microcontroller.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-26 15:03:30

Regarding the schematic diagram of the OMAP-L138 chip, please tell me
The company is going to use the OMAP-L138 chip for a board. We are using mentor to design the schematic. How do you get the chip library? It has 361 pins. Is there a pin list file like FPGA that can b
Distinguishing between CDMA and GPRS
Hi, I want to use VC to write a program to determine whether the mobile phone is using CDMA or GPRS, and then establish a connection. How can I determine whether the mobile phone is using CDMA or GPRS
Digital Communication System Test Tool - Arbitrary Waveform Generator
[i=s]This post was last edited by Stone_Mei on 2017-9-7 15:37[/i][b][font="]Overview[/font][/b][align=left]In the field of wireless communications, the development direction of communication signals i
LPC1500 experience + mbed development environment introduction 3, download and run
Series 2 We have successfully compiled our first program. When the compilation is completed and there are no errors, I will get the compilation result, a .bin format file. As shown in the figure below
Running the MSP430 at a crystal frequency other than 32.768kHz
[size=4] The MSP430x3xx devices are designed to use a 32kHz watch crystal and then generate an internal high-speed master clock (MCLK) from a separate, internal digitally controlled oscillator (DCO).
ULN 2803a and PLC usage issues
Hello everyone, I would like to ask a question: PLC s7 312 output is connected to the pull-up resistor 10kΩ connected to the input of uln 2803a, the COM terminal of uln 2803a is connected to 24v, and

Datasheet More

Circuits More