c9Rwi41

Traversing machine arm wiring board

Overview

Note: The thickness of the copper foil for free proofing is 1oz. If you have a large current, it is recommended to thicken the copper foil.

1. Used for wiring the motor and flying tower of the traversing machine, 4CM long and 1CM wide

2. When using a 4-layer board, it is recommended to choose a 1.6mm board thickness. The installation effect is as follows:

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-18 21:33:34

The difference between EEPROM and Flash, called the real version
[color=rgb(0,0,0)] The full name of FLASH is FLASH EEPROM, but the operation method is different from that of conventional EEPROM. The biggest difference between FLASH and EEPROM is that FLASH operate
【Share your experience】Ghostly shadow
Everyone thinks this topic is incredible and is promoting feudal superstition! ! ! ! Actually, it is not. I often listen to the storytelling of "Shan Tianfang", which talks about Yue Fei's son Yue Tin
Problems with op amp optocoupler isolation circuit
When I was doing a temperature detection, I used the negative feedback circuit composed of the following op amp and optocoupler to isolate the analog signal. In the actual circuit, when the input sign
Help, the SD card cannot communicate normally, and the measured pin voltage is abnormal
When I read and write the SD card, FR_NOT_READY is always returned. The waveforms of the CD and DATA0 pins measured with an oscilloscope are abnormal. The SD card is powered by 3.3V and the processor
cp2102 experts come in
I'd like to ask for advice from experts on cp2102: 1. Can this IC enable direct communication between a computer and a microcontroller? 2. If it can, is there a difference between 3.3v and 5v? Can all
【MXCHIP Open1081】+Firmware Upgrade
Error message as shown

Datasheet More

Circuits More