宋元浩

esp32_N20 motor driver board

Overview

1. Supports two N20 motor drives with encoders (DRV8833), and also has power management functions (IP5306), power monitoring (INA226) and TFT screen display functions. It is powered by two 16340 batteries.
If you are interested in the complete structural components If you are interested, you can contact the author by commenting;
2. The author also referred to the esp32 handheld engineering design to design a remote control board that can support the replacement of the key board. By replacing the connector, various powerful functions can be expanded. After the board is returned and verified Release together, interested friends can follow and develop together;
I hope to communicate and learn with everyone

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-09 00:06:59

16-bit PIC microcontroller
#define SCL_1 PORTAbits.RA11 //74ls164 #define SDA_1 PORTAbits.RA10 #define E PORTBbits.RB13 //lcd #define RS PORTBbits.RB12 #define LCD PORTBbits.RB11 void delay_us(unsigned int j) { unsigned int i;
【Atmel SAM R21】 Driving the car chassis——Preparation
I have driven LEDs years ago, and now I want to drive a car chassis. I looked at the program from years ago and found that low level is on and high level is off, so I have to use a PNP transistor. My
Little Watermelon Learns Renesas MCU (1) IDE Construction
[i=s]This post was last edited by 574433742 on 2015-8-18 23:58[/i] I am not very familiar with Renesas MCU, and this IDE development is a bit tricky, but fortunately it is designed by Bai Ren MCU, and
Preliminary understanding and introduction of hardware
Hardware introduction Sensortile entire kit includes programming cable, bracket board, bracket expansion board, core board, battery, protective shell six parts. The most important are the bracket boar
Home Power Supply Selection Guide
The emergence of a stabilized power supply is directly related to the power supply status of the power grid. Whether you need a stabilized power supply and what functions you need should be considered
Air conditioning maintenance knowledge
Air conditioning installation, fault repair....

Datasheet More

Circuits More