knAJI70ks

J-Link BASE V9 (Jlink V9)

Overview

Attention!!!

Select 7628 stack-up.

The project

uses a generic housing with a Type-C interface and provides a Vref/3.3V power switch (an indicator light will illuminate when switched to 3.3V).
Remove the RTCK signal cable.

Note:

Special note: H1 in the BOM is unnecessary. Purchase an 8.35mm Type-C adapter; standard ones will be slightly recessed.

The Type-C interface requires enlargement. The switch also needs additional drilling depending on the situation (if switching is infrequent, the switch can be removed; one of the case and graphics card will always need to be removed).

Download requires 1.27mm pitch probes; the adapter provides 1.27mm 2x5 and 2x7 adapters, as shown in the image.

PDF_J-Link BASE V9 (Jlink V9).zip

Altium_J-Link BASE V9 (Jlink V9).zip

PADS_J-Link BASE V9 (Jlink V9).zip

BOM_J-Link BASE V9 (Jlink V9).xlsx

93092

electronic

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2026-03-24 15:43:58

Proteus software simulation color screen TFT320240
[color=#333333][font="][size=14px]When using Proteus to simulate a color screen, the color screen module TFT320240A in the component library (as shown in the figure), what is its driver chip model? Th
About Multilayer Board Design
I am drawing a 4-layer PCB for the first time and I use a lot of blind vias. Will this cost more when making the board?
After installing DriverStudio, the test program cannot be compiled!!!!! Urgent reply!!!!
Install the following software: VisualStudio6.0, Windows2000DDK, and DriverStudio. Install them in order. In vc++6.0 (1) Select the menu File\Open Workspace. Open the workspace file located at DriverS
Recommended wireless technology development boards
I want to systematically learn about wireless technologies, including Bluetooth, ZigBee, and WiFi, mainly including the understanding of the protocols, driver software development, and how to develop
How to write a short message program using EVC?
I want to develop a short message program on a PDA. The PDA I bought has a CDMA module. I want to write a program that can send and receive short messages after inserting a Unicom card, and store them
NOx sensor
Could you please tell me which companies in the world can produce or successfully develop nitrogen oxide sensors? Thank you!

Datasheet More

Circuits More