Introduction: After actual testing, I found that the S parameter was not very good and failed. I have made a new one. The project link is in the article. The board material is RF4, the interface is SMA, the gain is 8.85dBi, and it is a 4-unit PCB Yagi antenna resonating at 1420MHz.
Introduction: 2.4GHZ wireless radio frequency communication can be used on student time cards and parking management system pdf document si24r2e.pdf
Introduction: 5.8G dual twin rhombus antennas. Sourced from public information on the Internet. The actual measured effect is close to that of a 14db flat panel. Looking forward to your draw distance test
Introduction: Use the cheap 433 device with long transmission distance to trigger the smart linkage of Mijia APP
Introduction: The fancy ESP32S2 development board Cube series 016 project (deprecated standard)
Introduction: The initial version of the 1420Mhz PCB Yagi antenna has been sampled and tested. For subsequent versions, you can refer to another expert’s https://oshwhub.com/bi6mht/1420MHzde-PCBba-mu-tian-xian
Introduction: XL2380 module development board, with supporting routines and blog posts.
Introduction: Improved based on the existing antenna on the forum, the original antenna is connected to https://oshwhub.com/kxxxxc/yagi_ant
Introduction: Using stm32 master control, adding a low-power Bluetooth module and a fingerprint sensor, you can use a card, fingerprint or wireless to open the dormitory door
Introduction: A simple remote control car that uses Hummingbird Wireless Ling-T3A as the transmitter module and Ling-R1 as the receiver.