Cruelfox, a forum expert, has updated his article to share with you an experimental idea of a CNC experimental power supply. The power supply uses two domestic chips, with a 3,000-word detailed explanation. He briefly talked about the first experimental power supply he made, whose shell was an aluminum medicine box and whose knob was a toothpaste cap. He mainly talked about the ideas and principles of the current mini PCB pocket version.
WiCAN is a powerful CAN adapter based on ESP32-C3 that can be used for car hacking and general CAN bus development. It is available in two form factors: OBD-II and standard USB-CAN. The original firmware can interact directly with RealDash using Wi-Fi or BLE, which allows you to create custom dashboards with beautiful graphics. It is available for Android, iOS, and Windows 10. WiCAN connects to your existing Wi-Fi network and any device on that network, and it allows you to configure Wi-Fi and CAN settings through a built-in web interface. Both versions have a power saving mode that detects when the voltage drops below 13 V or other preset values. When this power saving mode is enabled, WiCAN is able to enter sleep mode, reducing the current consumption to less than 1 mA.
Despite the growing demand for larger battery cells, battery prices remain quite high, constituting the most expensive component in an EV or PHEV, with a typical price tag of around $10,000 for a battery that supports a range of a few hundred kilometers. The high cost can be mitigated by using lower-cost/refurbished battery cells, but such cells will also have greater capacity mismatches, which will reduce the available runtime or driving distance on a single charge. Even higher-cost, higher-quality battery cells will age and mismatch after repeated use. There are two ways to increase the capacity of a battery pack with mismatched cells: one is to use larger batteries from the beginning, which is not cost-effective; the other is to use active balancing, a new technology that can restore battery capacity in the battery pack and quickly increase power. Full series battery cells need balancing When each battery cell in the battery pack has the same state of charge (SoC), we say that the battery pack is balanced. SoC refers to the current remaining capacity of an individual battery relative to its maximum capacity as the battery is charged and discharged. For example, a 10Ah battery will automatically equalize the state of charge between parallel-connected battery cells over time as long as there is a conductive path between the battery cell terminals. It can also be argued that the state of charge of series-connected cells will vary over time for a variety of reasons. Temperature gradients across the pack, impedance, self-discharge rates, or differences in load between individual cells can cause gradual changes in SoC. While pack charge and discharge currents help to minimize these cell-to-cell differences, the cumulative mismatch will only increase unless the cells are periodically balanced. Compensating for gradual changes in cell SoC is the most fundamental reason to balance series-connected cells. Typically, passive or dissipative balancing schemes are sufficient to rebalance the SoC of cells with similar capacities in the pack.
DC1018B-B, an overvoltage protection regulator demonstration board for the LT4356-2 with auto-retry capability where the auxiliary amplifier remains on during shutdown.
Typical Application of NCV890203 2.0 A, 2 MHz Automotive Step-Down Switching Regulator with RSTB. The NCV890203 is a fixed frequency, monolithic, step-down switching regulator designed for automotive battery-connected applications that must operate from an input supply up to 36 V.
EEWorld
subscription
account
EEWorld
service
account
Automotive
development
community
Robot
development
community
About Us Customer Service Contact Information Datasheet Sitemap LatestNews
Room 1530, 15th Floor, Building B,
No.18 Zhongguancun Street,
Haidian District,
Beijing, Postal Code: 100190
China
Telephone: 008610 8235 0740
京公网安备 11010802033920号
