Electrical Characteristics at test current for LUXEON Q
Junction Temperature = 85°C
Table 3.
Forward Voltage V
f
(V)
[1]
Nominal
ANSI CCT
Minimum
2.75
2.75
2.75
2.75
2.75
Maximum
3.25
3.25
3.25
3.25
3.25
Typical Temperature Coefficient
Typical Thermal Resistance
of Forward Voltage
[2]
(mV/°C) Junction to Thermal Pad (°C/W)
DV
F
/
DT
J
Ru
J-C
-1.6
-1.6
-1.6
-1.6
-1.6
7
7
7
7
7
2700K
3000K
3500K
4000K
5700K
Notes for Table 3:
1. Philips Lumileds maintains a tolerance of ± 0.06V on forward voltage measurements.
2. Measured between T
J
= 25°C and T
J
= 110°C at I
f
= 350 mA.
Absolute Maximum Ratings
Table 4.
Parameter
DC Forward Current (mA)
[1] [2]
Peak Pulsed Forward Current (mA)
[1] [3]
ESD Sensitivity
LED Junction Temperature
[1]
Operating Case Temperature at 700 mA
Storage Temperature
Soldering Temperature
Allowable Reflow Cycles
Reverse Voltage (Vr)
[4] [5]
Notes for Table 4:
1. Proper current derating must be observed to maintain junction temperature below the maximum. For additional information on thermal measurement guidelines please
refer to Application Brief AB118 (not available yet).
2. Residual periodic variations due to power conversion from alternating current (AC) to direct current (DC), also called “ripple”, with frequencies
≥
100 Hz and amplitude
≤
150 mA are acceptable, assuming the average current throughout each cycle does not exceed 1050 mA.
3. Pulsed operation with a peak drive current of 1200 mA is acceptable if the pulse on-time is
≤
5 ms per cycle and the duty cycle is
≤
50%
4. Transient reverse voltages and surge currents due to electrical switching or supply interruptions are acceptable if these events do not last for more than 10ms, the
amplitude of the reverse voltage does not exceed 5V and the reverse current is less than 200μA.
5. Max 5V reverse for up to 10s is an acceptable beginning of life, one time test condition.
LUXEON Q
1050
1200
< 8000V Human Body Model (HBM) Class 3A JESD22-A114-E
135°C
-40°C - 135°C
-40°C - 135°C
JEDEC 020c 260°C
3
LUXEON Q LEDs are not designed to be driven in reverse bias
[i=s]This post was last edited by qwqwqw2088 on 2020-7-2 10:33[/i]What are the advantages and disadvantages of current feedback op amps and voltage feedback op amps? Can op amps be used as comparators...
Most commercial radar systems, especially those in advanced driver assistance systems (ADAS), are based on silicon germanium (SiGe) technology. Today’s high-end vehicles have a multi-chip SiGe radar s...
Decoupling equivalent circuit of coupled inductor 1. Single-side same-name terminal connectionFigure 7-4-1 Connection of the same-name terminals on one side of a coupled inductor and its decoupling eq...
With the development of automobile technology, especially the development of computer and network technology, automobile electronics has undergone fundamental changes. At present, more than 30% of the...
This forum seems to have given out prizes, but no one has received them so quickly, right? I got it from the deyisupport.com community. I posted the original stuff casually and participated in the MSP...
1. Introduction
RFID (radio frequency identification) is a non-contact automatic identification technology that emerged in the 1990s. It uses the characteristics of radio frequency signal prop...[Details]
Remote keyless entry (RKE) systems have become popular with users, with more than 80% of new cars in North America and more than 70% in Europe equipped with RKE systems. In addition to the obvious ...[Details]
No matter which processor you are learning, the first thing you need to understand is the registers and working mode of the processor.
ARM has 37 registers, including 31 general registers and ...[Details]
In recent years, lighting has become an important area that countries around the world are targeting to promote energy conservation and environmental protection. According to statistics, about 20% ...[Details]
Electronic systems are located at different points on the automotive power bus and therefore often need to operate under very stringent power requirements. These include load dump, cold crank, very lo...[Details]
Battery life is critical for portable applications. For applications such as smoke detectors, security devices, and thermostats, factory-installed batteries need to last for more than 10 years. The...[Details]
To differentiate their products in a crowded and competitive market, manufacturers of handheld devices often consider battery life and power management as key selling points for cell phones, PDAs, ...[Details]
July 11, 2012, Beijing - Altera Corporation (NASDAQ: ALTR) today announced the launch of 40-Gbps Ethernet (40GbE) and 100-Gbps Ethernet (100GbE) intellectual property (IP) core products. These core...[Details]
Images in science fiction movies often break through the limits of reality, such as in the movie "Minority Report." Tom Cruise uses a multi-touch screen to browse information. Capacitive sensing te...[Details]
1. Introduction
Testing the temperature of steel billets before rolling is an important measure to ensure the quality of steel. Traditional manual testing is difficult to ensure product qu...[Details]
Xiaomi, a well-known Internet phone in mainland China, won a million-unit order contract from China Unicom on November 20 last year, which made Xiaomi famous in mainland China. In April this year...[Details]
1 Introduction
In recent years, there have been many major advances in the production technology and processes of automotive headlights, which have greatly improved the performance of automoti...[Details]
With the advocacy and implementation of the government's Safe City Plan, the security market has increasingly higher requirements for the clarity of surveillance images. Imagine that after a case o...[Details]
In the single-chip microcomputer system, in addition to display devices, sound devices are often used, and the most common sound device is the buzzer. Buzzers are generally used for some low-demand...[Details]
Experimental tasks
A DS18B20 is used to form a temperature measurement system. The temperature measurement accuracy reaches 0.1 degrees. The temperature range is between -20 degrees and +50 de...[Details]