MSP430 interrupt nesting mechanism(1) 430 disables interrupt nesting by default, unless you enable the general interrupt EINT again in an interrupt routine.(2) When entering the interrupt program, as
When I use AD10 to draw schematics, there is no red wavy warning next to the components when the components have the same name. AD6.9 has this warning. Why? Do I need to set some rules? I tried settin
[i=s]This post was last edited by Li Baiyi on 2019-5-18 20:38[/i]Software architecture: [font=宋体][size=4]1. Firmware library file: [/size][/font][font=宋体][size=4]GD32E23x_Firmware_Library[/size][/font
I. Overview: --- A monitoring system (hereinafter referred to as monitoring system) is an auxiliary equipment for technical prevention and scientific management. At the beginning of its introduction,
[i=s] This post was last edited by gaon on 2014-7-23 16:34 [/i] Use the FPGA Power Design Tool to record, select the FPGA Power Design Tool tab, the following interface appears, click the PROCESSER bu