• You can log in to your eeworld account to continue watching:
  • Hands-on practice-kernel multi-tasking concurrency example (Part 2)
  • Login
  • Duration:12 minutes and 8 seconds
  • Date:2019/10/25
  • Uploader:老白菜
Introduction
In the study of the huge Linux kernel source code, how to grasp the main clues and ideas, and how to effectively apply what has been learned, the main lecture of this course is based on my 20 years of research and teaching on the Linux kernel. Effective summary, using the separation of mechanisms and strategies as the guiding ideology, analyzes the design ideas and data structures of the Linux kernel, allowing everyone to enter the Linux kernel by writing Linux kernel modules and analyzing source code after studying each chapter. door. At the same time, we invite kernel expert Mr. Xie Baoyou and front-line engineer Zhang Tianfei to share their many years of experience in kernel combat at the front line of enterprises, so that you can be consistent in your hands-on practice, from theory to practice, and from practice to theory, open up the connection between knowledge, and master the system. Level software design ideas and methods. Welcome everyone to learn the top work in the open source world - the Linux kernel.
Unfold ↓

You Might Like

Recommended Posts

How do I use this command on Renesas H8/300H 3039?
mov.b @(d:16,ERs),Rd 1. Thank you
jeans703 Embedded System
Strange phenomenon of stm32 clock and can baud rate
I used 103 to develop a CAN program. The crystal oscillator on the board is 16M. The clock configuration uses the official program SystemInit(). The SYSCLK_FREQ_72MHz macro is also defined. Theoretica
字字宫商 stm32/stm8
Share several multisim9 simulation circuits
There are 555, D flip-flop, counter and NAND gate.
navigat Analog electronics
About the transplantation of vivi on s3c2410
Due to project needs, vivi needs to be ported to S3C2410. The default baud rate of vivi is 115200, which needs to be changed to 9600, MPLL is 200MHZ, and the frequency division is 1:2:4. Then set a ma
zgy8864 Embedded System
Linux kernel print output hyperterminal cannot display information
I need help urgently. The kernel cannot output print information. For example, the sentence printk("leds:register device sucess!"); should be available on the hyperterminal, but I followed the instruc
18811707971 Linux and Android
【MXCHIP Open1081】Publish a web page
[i=s]This post was last edited by ljj3166 on 2014-12-27 17:47[/i] On the weekend, I stayed at home with a cool breeze outside, and tinkered with OPEN1081 again. I looked at the webserver routine and t
ljj3166 RF/Wirelessly

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号