Training

Location:Training / Robot / Basic Principles of Robotics Fang Lijin, Northeastern University / Build a robot model

You can log in to your eeworld account to continue watching：
Build a robot model
Login

Duration：9 minutes and 15 seconds
Date：2020/02/13

Uploader：JFET

Introduction

keywords： robot

Robot kinematics and dynamic modeling are the key teaching content of this course. Through this course, students can understand and master the basic principles and modeling methods of robots, establish a systematic and complete basic theoretical system, and prepare for subsequent in-depth study of robot intelligent control and other courses. Build the necessary knowledge base. Focusing on the key content of the course, we designed knowledge points including robot kinematics, dynamics, drive system, posture and trajectory control, force control, intelligent control and MATLAB-based simulation, and initially established and formed course knowledge with its own characteristics. Architecture.

You Might Like

Recommended Posts

Strong 51 MCU knowledge is essential for the competition: [i=s] This post was last edited by paulhyde on 2014-9-15 09:24 [/i] Strong 51 MCU knowledge is required for the competition; woshishiyanshj Electronics Design Contest

I want to compare data inside FPGA and output the maximum value, but there is a problem during simulation. I hope you can answer this question!: Let me first tell you my idea: I want to continuously send 8-bit data to the FPGA, and then send out the previous largest data (so I need to keep comparing) when a certain IO port is at a high level.; HDU_Kingso FPGA/CPLD

HT46R47 controls multi-point temperature acquisition system: For those who do scientific research, this can be said to be the most classic example.; rain Industrial Control Electronics

How to measure the power of high-current and high-capacity lithium batteries?: The current demand is to accurately measure the power of large-capacity and high-current lithium batteries. Do you have any chip recommendations? The equipment is used on drones.; sunnyicecream Analogue and Mixed Signal

Key interrupt adjusts PWM pulse duty cycle to adjust LED brightness: I am a beginner in MSP430. When I came into contact with TA, I wrote a program according to the example that can use the key interrupt to adjust the PWM pulse duty cycle to adjust the LED brightness.; jin1991 Microcontroller MCU

I encountered this knowledge point when debugging the code and I would like to share it with you. It may be very low-level knowledge.: [b]Excerpt from the expert's answer blog[/b][b][url=http://quanminchaoren.iteye.com/blog/1870977]The difference between #if, #ifdef, and #if defined[/url][/b][list] [b]Blog Category:[/b] [*][url=http:; WZH70246 MEMS sensors

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号