smallembedded

100 W automotive preregulator, non-isolated, synchronous buck reference design based on NCV881930

100 W Automotive Pre-Regulator, Non-Isolated, Synchronous Buck, NCV881930-Based Reference Design

Overview

This reference design describes the operation and the performance of a 100 W non-isolated synchronous buck automotive pre-regulator, based on the NCV881930 synchronous buck controller with four NVMFS5C460NL 40 VN-channel MOSFET. The reference design shows a complete design for an automotive pre −regulator for a broad range of applications, and highlights the capabilities of the

NCV881930 controller.

Documentation

100 W Automotive Pre-Regulator, Non-Isolated, Synchronous Buck, NCV881930-Based Reference Design

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-12 12:41:18

ucos iii time base variable overflow problem
For STM32 MCU, the localtime variable is set to 32bit and the systick division frequency is 1000Hz. Then after running for 49 days, the localtime variable will overflow. At this time, calling the dela
Please help me check if the signal acquisition program is OK. Is it correct that the signal processing program has been simulated separately?
The idea of the acquisition part is to collect 16 signals from the signal source and then process them#includereg51.h #include stdio.h #include absacc.h #include math.h #define PI 3.1415926; #define u
EEWORLD University - How to use independent measurement ADC to design high-precision CT phase meter
How to design a high-precision CT phase meter using an independent metrology ADC : https://training.eeworld.com.cn/course/5292This module provides details on the characteristics of shunts and current
Equipped and ready to go, a must-have list for self-driving in Tibet
The car friends "Qingka" and "JEEP Wrangler" have driven to Tibet many times and have rich experience. If you are planning to travel to Tibet by car, I hope this list of essential items for self-drivi
STM32F769I-DISCO Review [1]—— Unboxing photos of "ST769 mobile phone"
[i=s]This post was last edited by qwerghf on 2016-12-11 20:28[/i] I am honored to have the opportunity to review STM32F769I-DISCO. Thank you very much. I have been waiting for the courier information
Please help me check if the program is correct! Thank you (circuit diagram attached)
The program is as follows: KEIL debugging is correct, but there is a problem with simulation! Can you help me modify it! [code] #include #define keyR P0 #define keyC P0 sbit DE=P3^4; //sbit RD=P3^7; /

Datasheet More

Circuits More