念慈菴

TRK-S12ZVL: StarterTRAK development board for MagniV S12ZVL MCU for LIN applications

Overview

TRK-S12ZVL is equipped with the 16-bit automotive MCU series S12ZVL. This product integrates an S12Z CPU, a LINPHY interface, a 5V built-in LDO capable of operating at car battery levels (with the option to control an external ballast transistor), and a high-voltage input pin on a single chip.

The S12ZVL family offers program Flash, EEPROM and SRAM memory with error correction code (ECC), a 10-bit fast ATD converter, and a frequency modulated phase-locked loop (PLL) for enhanced EMC performance.

MoreCollapse

Documentation

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-28 20:09:18

Will P1REN affect P1OUT? Please help me do an experiment if you have EZ430-F2013. It is very simple.
From the P1 port diagram provided by TI, the output of P1OUT.0 is not affected by P1REN.0. However, if you do an experiment, you will find that this is not the case at all:The following analysis uses
Use of NWAIT signal in SMC in AT91RM9200 ARM
I don't understand the description of NWAIT in the datasheet. Is it like this? For example, for an external FPGA, after EBI outputs a read command to the peripheral, the peripheral FPGA pulls the NWAI
Can you tell me about the OD gate pull-up resistor?
I would like to ask how to calculate the pull-up resistor of an OD gate. Why is n the number of load gates instead of the number of input terminals for a NAND gate load? See the figure below. I am a n
Received samples of SC8721 etc. that the forum helped to apply for
Because you want to DIY a fast-charging version of the constant temperature soldering iron, in order to achieve wide voltage inputs such as 5V, 12V, and 20V, you need to use a boost chip. By using the
Single-tube ADS-based simulation steps "Basic process"
Single tube simulation preparation1. Have basic ADS operation capabilities, including DC simulation, S parameter simulation, harmonic simulation, etc. 2. Have basic theoretical knowledge of transmissi
The annoying DE1-SOC requires a license for everything. I regret buying it.
The annoying DE1-SOC requires a license for everything. I regret buying it.

Datasheet More

Circuits More