0k5NLUQ80

touch light strip

Overview

Because the previous light bar was drawn incorrectly, draw a new one.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-08-08 15:03:07

My EK-LM3S811 board is locked? What should I do?
My EK-LM3S811 board is locked. I used the JTAG port by mistake. Some netizens said that it can be unlocked. I tried many ways, but none of them worked. Do I really need to change the chip? But where c
Please advise, arm
From electronic engineer technical exchange (12425841)[, +/-] [, +/-]! What are the differences between the three addressing modes [], +/- ? They are almost the same according to the introduction.
I need help with the USB Function driver issue in wince5.0!
How is the USB function controller driver of wince5.0 loaded? How are the interface functions such as UFN_Init in Ufnmdd.cpp called and executed? In the source file, only a usbmddbase.lib library is g
The circuit observation room has changed
The current state of the circuit observation room is unbearable to look at. It is completely different from the original purpose of its establishment and it is not maintained. It is better to have few
[Help] A problem occurs when using CCS4 to Launch TI Debugger in the target option
When using CCS4, I opened a project, compiled it correctly, and selected Target-New Target Configuration. After it was successfully established, I now selected the following Launch TI Target, and then
usb transfer rate
The WinCE device supports full-speed mode, but not high-speed mode. It is compatible with USB2.0. However, when the device is connected to the PC and enters storage (i.e. the device is used as a USB d

Datasheet More

Circuits More