手可摘棉花

OpenHeat: open source intelligent heating platform

Produced by Zhihui Jun, to be further updated

Overview

A practical heating table for PCB reflow soldering, which is quite cool.
Parameters: The hardware is based on the ESP32PICO-D4 chip, the input power is 24V/10A, the maximum power is 200W, and the heating temperature is up to 300°C; it has Bluetooth function. If you have time later, Zhihui Jun will develop a mobile APP to set the heating curve.

Design Files

OpenHeat-main

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-24 09:33:02

RFID Basics - Must-Read for Beginners
[size=9pt][color=#800080][font=Arial]RFID[/font][font=宋体]Basic knowledge[/font][/color][size=14pt]· [/size][/size] [size=9pt][color=#800080][font=Arial]RFID[/font][font=宋体]Application fields[/font][/c
If the voltage difference between the input and output of LDO is too small, will it have a bad effect?
If the voltage difference between the input and output of LDO is too small, will it have a bad effect? I have seen that many constant current LDO chips have a minimum voltage difference requirement of
Overview of Low Frequency Power Amplifier.ppt
Calling delete on pointer members in the destructor
[i=s]Last edited by paulhyde on 2014-9-15 09:21[/i] Most of the time, classes that perform dynamic memory allocation use new in the constructor and delete in the destructor. This is not hard to do whe
while statement optimization
How to optimize the following code using the stm32f103 chip?　 #define CONST_REGBUF_SIZE 32index=0;while(index{if((usedstatus[index]!=CONST_REGBUF_STATUS_READING)&inforegaddr[index]==tmpaddr)break;inde
Huang Zhiwei from the University of South China prepares for the 2013 Electronic Design Competition "Instrumentation" competition topic analysis
[i=s] This post was last edited by paulhyde on 2014-9-15 03:33 [/i] Huang Zhiwei from the University of South China prepares for the 2013 Electronic Design Competition "Instrumentation" category. Anal

Datasheet More

Circuits More