Training

Location:Training / Embedded Development / Embedded operating system / i.MX Linux Development Practical Guide / SPI physical bus

You can log in to your eeworld account to continue watching：
SPI physical bus
Login

Duration：9 minutes and 33 seconds
Date：2021/01/14

Uploader：抛砖引玉

Introduction

keywords： Linux

The first issue - Zero Basics Introduction - 47 episodes
The second issue - Kernel Programming - 20 episodes
The third issue - Bare metal development - 21 episodes
The fourth issue - Driver development - 82 episodes available

You Might Like

Recommended Posts

A question about kernel: I have bought the board for almost a month, but I have been stuck on several issues: 1. I don't understand why I need an SD card. I remember uImage is only a few MB. 2. I don't have a screen, and I do; klyz12ss DSP and ARM Processors

Help: Program to initialize SD card SPI mode: I have just started to learn about this field. I want to write a simple reading and writing program for an SD card in SPI mode. I have only read the documents these two days but have no idea what to d; shizhu72 Embedded System

See the question below. What method of communication is used?: [backcolor=rgb(222, 240, 251)]To control 30 points (temperature, switch), the lower computer has not been built yet, the position of each point varies from 10 meters to 100 meters, the construction pa; caoqing DIY/Open Source Hardware

Can the stream driver be written like this in wince?: BPH_Init( LPCVOID pBusContext ) { //Startup animation PROCESS_INFORMATION processInformation; HMODULE hinstance = LoadLibrary(TEXT("Coredll.dll")); FARPROC pFuc = GetProcAddress(hinstance,(L"CreatePro; bookworm Embedded System

E13C diesel engine helps Hino Profia achieve 2015 fuel efficiency standards ahead of schedule: Hino Motors will soon launch a large truck "Hino Profia " that meets the "2015 fuel efficiency standards " in some grades. The fuel efficiency standards have been implemented since April 1, 2006, and; frozenviolet Automotive Electronics

Why do low-frequency voltage sources generally not consider internal resistance, while high-frequency voltage sources such as 2M-30M generally have an internal resistance of 50 ohms?: Why do low-frequency voltage sources generally not consider internal resistance, while high-frequency voltage sources such as 2M-30M generally have an internal resistance of 50 ohms?; secondlife110 RF/Wirelessly

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号