Training

Location:Training / Embedded Development / Embedded operating system / i.MX Linux Development Practical Guide / PWM drive experiment

You can log in to your eeworld account to continue watching：
PWM drive experiment
Login

Duration：20 minutes and 30 seconds
Date：2021/01/14

Uploader：抛砖引玉

Introduction

keywords： Linux

The first issue - Zero Basics Introduction - 47 episodes
The second issue - Kernel Programming - 20 episodes
The third issue - Bare metal development - 21 episodes
The fourth issue - Driver development - 82 episodes available

You Might Like

Recommended Posts

【EEWORLD module arrangement】+ Integrated filter module: [i=s]This post was last edited by paulhyde on 2014-9-15 09:00[/i]Linear Many designs are completely correct from a theoretical analysis. But in the actual design, it is a headache to adjust. I remembe; hzp08041234 Electronics Design Contest

DC regulated power supply to charge the battery: The battery is 12V, and the DC regulated power supply (30V 5A specification) can be used to charge the battery directly? Without any load, the DC regulated power supply is adjusted to 15V 5A. Is it fe; stm32f103vct6 Power technology

Error: Flash download failed "cortex-m3" when downloading stm32: I use [backcolor=rgb(239, 245, 249)]stm32f103RBt6, and the downloader is jlink. I have also used stlink as the downloader, and the phenomenon is the same. . I can erase the flash, but I can't download; powered ARM Technology

Regarding the scanning problem of 51 microcontroller,: #includereg52.h #define uint unsigned int #define uchar unsigned char uchar code shumaguan[] = {0xc0,0xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80,0x90}; uchar code table[] = {0xfe,0xfd,0xfb,0xf7,0xef,0xdf,; wanandenidongde 51mcu

MSP430 Interrupts: #includeunsigned char t=0; unsigned int Time; void Clock_Init(void) { unsigned char i; BCSCTL1=~XT2OFF; //Turn on XT oscillator BCSCTL2|=SELM1+SELS+DIVS_3;//mclk=smlk=1MHz do { IFG1=~OFIFG;//Clear osc; ccec Embedded System

nrf24l01 multi-channel receiving problem: Only channels 0 and 1 can be used for reception. If EN_RXADDR is configured as multi-channel (0x03), it is not acceptable. I have been struggling for a long time. Please give me some advice! Part of t; 虚源草 RF/Wirelessly

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号