This course is a motor control course based on STM32 taught by Hard Rock Technology, including DC brush motor control, PID closed-loop controller, servo control, stepper motor drive and control, DC brushless motor drive and control, etc.
ABB550 series inverter, the motor is 37KW made by a small factory (not a variable frequency motor). The interference cannot be removed. The inverter has a separate power distribution cabinet, and the
I used the three-wire mode. After the host was running, the SCK corner had not been output. I used the UTR0 and SPI0 of 360. So when designing the pins, I skipped P0.1, P0.2, and P0.3 as a test port.
I found that this reset circuit can download the program, but it cannot be started. After pulling up a 10K resistor on NRST_MCU, it can work normally. Can you please discuss why this is? Thank you!
The program was originally compiled under QT and ported here. The normal code under QT is as follows: #define OUTPUT_DEBUG_INFO //Input debugging information to the terminal #ifdef OUTPUT_DEBUG_INFO #
I am not an expert, but my company needs a sensor for its new product. I would like some advice from experts. Requirements: 1. The sensing distance should be about 30cm, which is the distance between
The latest TI Industrial Application Seminar introduced the technology and development of TI products from multiple aspects and angles. The content involved multiple solutions in the hot DLP, industri