Training

Location:Training / Hot Applications / Industrial Control / STM32 motor control (Hard Rock Technology) / DC brush motor (Section 3)_Motor parameters and motor control basics

You can log in to your eeworld account to continue watching：
DC brush motor (Section 3)_Motor parameters and motor control basics
Login

Duration：1 hours and 3 minutes and 11 seconds
Date：2020/04/03

Uploader：木犯001号

Introduction

keywords： STM32 Motor BLDC Servo PID

This course is a motor control course based on STM32 taught by Hard Rock Technology, including DC brush motor control, PID closed-loop controller, servo control, stepper motor drive and control, DC brushless motor drive and control, etc.

You Might Like

Recommended Posts

Urgent! Urgent! Pyroelectric sensor + microwave sensor signal processing: I am doing a graduation project on anti-theft alarm. In the alarm information collection module, I want to use a combination of pyroelectric sensors and microwave sensors (dual detectors) to reduce th; 杨闯 Sensor

IP help document cannot be opened: When you want to view the help document about this IP, click DocumentationAt this time, the browser goes to the local to find the help document, but it prompts "Network cannot be accessed"Go to the lo; yin4319 FPGA/CPLD

Nokia N92 (DVB-H mobile phone).pdf: Nokia N92 (DVB-H mobile phone).pdf; wanilyccc PCB Design

Very simple second-order low-pass passive filtering: The cut-off frequency is 50Hz. Does it mean to use the formula of 1/2pi*RC? I feel that the calculation is wrong. Do I need to consider the gain, amplitude-frequency and phase-frequency?; 西里古1992 Analog electronics

KW41 Development Kit - Electronic Label DIY Process #2 Try both software and hardware: 1. During this process, I have been transplanting the LCD1602 library, but the software has used many solutions but none of them worked. Finally, I found the reason. The PTC4 pin is reused. On the FRD; fyaocn NXP MCU

(The problem has been solved) Ask Vivi's load flash Vivi x problem: I found a clean vivi, transplanted it, put jtag on the development board, and then connected it with dnw.exe. After entering the vivishell, I used bon part 0 192k 1216k partition. After completion, I; tigerlikes Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号